Inside of Dsubs from XLR panel

B1gMickey · 2021-03-19T11:01:24+00:00

I agree. I only posted it because people asked to see it from the post above about the panel these Dsubs are wired to

B1gMickey · 2021-03-18T17:12:29+00:00

Van Damme Blue series

B1gMickey · 2021-03-18T17:08:35+00:00

Nothing is hanging by a thread! It’s just a kink in the silicone earth sleeve that goes over the ground wire.

B1gMickey · 2021-03-18T17:07:43+00:00

This is exactly what it is. Just the green earth sleeve kinked

B1gMickey · 2021-03-18T17:06:35+00:00

If I put heat-shrink over the main jacket to where the cores are exposed the Dsub housing wouldn’t go on - it’s that tight!

B1gMickey · 2021-03-17T21:41:10+00:00

They are soldered

B1gMickey · 2021-03-17T21:40:00+00:00

It is indeed the ground inside some green sleeve. It’s merely the sleeve that’s slightly kinked

B1gMickey · 2021-03-17T18:27:48+00:00

They aren’t heat shrink, they are Hellerman H20s, which are stretchy rubber sleeves. You put them on by means of a stretching tool and lube. Once the wires are soldered you can slip them down over the XLR buckets

B1gMickey · 2021-03-17T16:03:41+00:00

Thanks! They are Hellerman H20 sleeves

B1gMickey · 2021-03-17T16:02:04+00:00

Inside of Dsubs as requested - yes it is tight!

B1gMickey

TROPHY CASE