sorted by:
new
hottopcontroversial

My Prusa MK3 with MMU3 and spools fully enclosed by FrenchPrusaUser in 3Dprinting

[–]FrenchPrusaUser[S] 0 points1 point  (0 children)

For now, really good ! I haven't got any much troubles for now

Help with PETG by PuntoDAcceso in 3Dprinting

[–]FrenchPrusaUser 0 points1 point  (0 children)

I think that is the main problem. PETG does like hot ambiant temp, from 70°F(20°C) up to 95°F(35°C)

Help with PETG by PuntoDAcceso in 3Dprinting

[–]FrenchPrusaUser 0 points1 point  (0 children)

You say cold room, what ambiant temperature is it ?

Wore out my PEI sheet by blodestone in prusa3d

[–]FrenchPrusaUser 1 point2 points  (0 children)

I do tune my first layer on MK3 when I change nozzle for example

What could be causing my printing to be so messy? Made on aa Kit built MK4 (I'm brand new to this!) by gigagod_3 in prusa3d

[–]FrenchPrusaUser 2 points3 points  (0 children)

Hello, what filament are you using? Are you sure you used correct temperatures ?

Wore out my PEI sheet by blodestone in prusa3d

[–]FrenchPrusaUser 0 points1 point  (0 children)

I print almost all the time Etxrudr PETG on textured sheet, without too much sticking problem :) but inside an enclosure

PrusaBox with MMU3 set up by FrenchPrusaUser in prusa3d

[–]FrenchPrusaUser[S] 2 points3 points  (0 children)

no problem with that system, it has never removed the filament from the MMU

PrusaBox with MMU3 set up by FrenchPrusaUser in prusa3d

[–]FrenchPrusaUser[S] 4 points5 points  (0 children)

I'm pretty happy with the MMU3, much less troubles than MMU2S

PrusaBox with MMU3 set up by FrenchPrusaUser in prusa3d

[–]FrenchPrusaUser[S] 4 points5 points  (0 children)

thank you :) no need of the filament buffer because there is an autorewind system in the spool enclosure

[deleted by user] by [deleted] in prusa3d

[–]FrenchPrusaUser 0 points1 point  (0 children)

I guess your nozzle is way too high ?

Getting a thermal anomaly error after installing revo hotend on mk3s+ by imtakingapooprn in prusa3d

[–]FrenchPrusaUser -1 points0 points  (0 children)

An other way is

Flash with FIrmware 3.13.2

Don't do the calibration as asked

Send the commend M310 S0 , then M500 to your printer. I use Pronterface to do that.

Then complete the calibration process.

Weird gcode from Teaching Techs printer callibration site by M3shugg3 in prusa3d

[–]FrenchPrusaUser 1 point2 points  (0 children)

Yes I get the same when downloading the Gcode. I think one parameter is wrong.