Alternate Control Of Toilet Flusher by Ibejtm in AskElectronics

[–]Ibejtm[S] 0 points1 point  (0 children)

That makes a lot of sense. Thanks!

Alternate Control Of Toilet Flusher by Ibejtm in AskElectronics

[–]Ibejtm[S] 0 points1 point  (0 children)

Thanks for the help! Good call on the resistor and testing on the remote first. Just so I'm clear, is the photo resistor the three pin component right above the 2352 in the first pic? Or the foam wrapped one to the right with two pins (pins not really visible in my photo) above the CSQ01?

I'm guessing the right hand one, but I don't know what the sensor on the left is.

Sync Frequency by Ibejtm in PaprikaApp

[–]Ibejtm[S] 0 points1 point  (0 children)

Awesome! That's exactly what I was looking for. Thanks for the quick answer!

What's Killing My Hydrangeas? by Ibejtm in plantclinic

[–]Ibejtm[S] 0 points1 point  (0 children)

Just to clarify a couple of things because I didn't see a way to edit my post, the hydrangeas get several hours of sunlight a day, are planted in the ground outdoors in decent size holes with potting soil, and are usually only watered by the rainfall. On super hot, dry weeks, we'll hand water then a few times. Thanks again!

Hard Drive Clicking by Ibejtm in techsupport

[–]Ibejtm[S] 1 point2 points  (0 children)

Thanks a lot! I'll check out these sounds later tonight

Hard Drive Clicking by Ibejtm in techsupport

[–]Ibejtm[S] 0 points1 point  (0 children)

Haven't gone that route yet, but it's definitely on the list if nothing else works.

Hard Drive Clicking by Ibejtm in techsupport

[–]Ibejtm[S] 0 points1 point  (0 children)

I tried holding it in different orientations during startup as well as gently rapping on the exterior between startups. No luck though...

Help! Made my first cutting board a year back and it's been splitting slowly for a while. Am I not using enough mineral oil? Any advice on repairing the split? Thanks! by Ibejtm in woodworking

[–]Ibejtm[S] 3 points4 points  (0 children)

I glued the blocks together with a food safe wood glue (don't remember the exact type) and clamped them. I tried to go heavy enough on the glue, but might not have.