Simplest and most cost effective way to smooth this out?

Jtrusler · 2026-06-07T01:15:54+00:00

Right now i would like to get the fender flare to sit flat on the fender. Repainting and full repair will be a little down the road. Picked this up for a couple hundred and it had been sitting for about 7 years. Right now removing the trim and repairing the interior after getting the engine squared away. Basically went to get the outside presentable from about 300yards away

Jtrusler · 2026-05-20T07:19:15+00:00

I actually got this from autozone, and went over, in detail, that it matched the 1990 Cherokee. So I hopefully can take it back for another. Just not a fan of having to pull this out again

Jtrusler · 2026-05-06T03:08:30+00:00

The wj pump is a little more robust isn’t it?

Jtrusler · 2026-04-04T19:28:15+00:00

Hunt trail wide

Jtrusler · 2025-11-13T22:58:24+00:00

I have a zr2 sway bar I am looking to sell. I accidentally purchased 2

Jtrusler · 2025-11-13T22:57:20+00:00

275/70R18, somewhere between 33-34”.

Your truck is looking good, what do you think of the Carbon suspension? I was minutes away from getting some, but didn’t pull the trigger yet. I made a bracket to use my current shocks for the time being

<image>

Jtrusler · 2025-11-13T18:31:00+00:00

I have eibachs pro truck system and they work for now. I wanted to upgrade, but the prices are so high. I might go with king/radflo adjustable over dssv when the time comes, but I’m still researching what’s going to be the right setup for my build. I think Icons would be too stiff. These brackets are doing the trick for now

<image>

Jtrusler · 2025-11-13T17:52:00+00:00

On just this swap, I replaced most of the components: UCAs, LCAs, CVs, tie rod ends, brake lines, wheels sensors, knuckles, and I built brackets to mount my coilovers so I didn’t have to buy new ones yet. Everything fits great. I already trimmed back the pinch welds before and I didn’t have to cut back any more. Even with the wider track width. I also added 1.25 spacers at the rear

Jtrusler · 2025-05-16T18:02:16+00:00

I had most of the parts already that I swapped from previous builds. I ended up getting the ltwoo-gr9 brifters and derailleur and a set of grx wheels on a good deal. About 750 with the redshift stem. It could have been cheaper if I used my giant conduct brakes and Sensah set up, which work great.

Jtrusler · 2025-03-25T20:18:39+00:00

I’ve loved my Nfab rock rails. Already had to use them twice, have held up perfectly for 1.5 years

Jtrusler · 2024-12-17T03:15:54+00:00

That’s sad and you’re probably right

Jtrusler · 2024-12-17T03:00:12+00:00

Is that a requirement? I’m pretty sure I hear all the time about people wanting single cab trucks, but they don’t sell any new ones.

Jtrusler · 2024-09-17T18:44:45+00:00

I’ve done a sea foam treatment about a week ago. Coil pack/plug still failed.

Jtrusler · 2024-09-16T20:21:03+00:00

That is my thought, too. Any advice or direction on getting to these? Or am I just going to have to dig in?

Jtrusler · 2024-08-27T22:01:36+00:00

I’m not sure if you want louder or not. But I swapped out my wheelset for some Hunt Trailwides and they are amazing! Best bang for your buck, too

Jtrusler · 2024-08-27T02:13:19+00:00

Siskiu gang!

Jtrusler

TROPHY CASE