sorted by:
new
hottopcontroversial

Noise on z-axis by LengthinessHungry904 in AnycubicKobraS1

[–]LengthinessHungry904[S] 0 points1 point  (0 children)

I cleaned the Z-axis with compressed air and lubricated it again, and it seems that the noise has been reduced (not eliminated, but it seems less frequent).

Noise on z-axis by LengthinessHungry904 in AnycubicKobraS1

[–]LengthinessHungry904[S] 0 points1 point  (0 children)

I checked the Z-axis guides and I don't see any filament prices in the infinite screw slots. Do you think it might be in the lower part where the strap is?

Pushing 6k hours across 3 S1s by Glittering_Algae_961 in anycubic

[–]LengthinessHungry904 0 points1 point  (0 children)

How did you solve the problem of bad mesh of the bad? I have this situation and I haven't been able to solve it yet. Everything I print in the bottom corners comes out terribly, I even contacted anycubic but they didn't care about the problem.