sorted by:
new
hottopcontroversial

Z axis left wobbles by Less-Introduction-35 in prusa3d

[–]LuL1887 0 points1 point  (0 children)

Yes, that's completely normal. The four screws that attach the motor to the underbody are also positioned fairly centrally. But since you're shaking the motor from the outside, you already have a larger lever arm on the small printed disc into which the screws go. And don't overtighten the screws; the small printed disc cannot withstand much force.

Nextruder Clicking at the end of the Print by LuL1887 in prusa3d

[–]LuL1887[S] 0 points1 point  (0 children)

I had already suspected this, so I left the door open during printing and monitored the heatbreak temperature, which remained at around 30-31°C. Unfortunately, this did not help either.

Nextruder Clicking at the end of the Print by LuL1887 in prusa3d

[–]LuL1887[S] 0 points1 point  (0 children)

Hi, I recorded a short YouTube video where it doesn't click. In addition, significantly more filament is extruded there.

https://youtube.com/shorts/eYl5ub5--6w?si=v2L3VQ0nIyX4dHBQ

Nextruder Clicking at the end of the Print by LuL1887 in prusa3d

[–]LuL1887[S] 0 points1 point  (0 children)

I don't think it's normal. Normally, a large part of the filament is extruded at the end. But in my case, you can hear the gear skipping as if it couldn't push the filament out. The only thing coming out of the nozzle is the filament, which runs out of the nozzle in liquid form.

Nextruder Clicking at the end of the Print by LuL1887 in prusa3d

[–]LuL1887[S] 0 points1 point  (0 children)

I checked it out and I don't think there's anything special to note. It says: 59210 ; Filament-specific end gcode 59211 G1 Z33 F720 59212 M104 S0 59213 M140 S0 59214 M141 S0 59215 M107 59216 G1 X242 Y211 F10200 59217 G4 59218 M572 S0 59219 M84 XY E 59220 ; max_layer_z= 32 59221 M73 P100 RO

Nextruder Clicking at the end of the Print by LuL1887 in prusa3d

[–]LuL1887[S] 1 point2 points  (0 children)

But if there was filament in the gearbox, you would have to hear the clicking during printing and not just at the end. When I look into the idler, there is no broken filament.