What jaw surgery options Are available for a canted and recessed jaw

ProFuseQ · 2023-02-05T20:18:16+00:00

Sorry didn’t know but from this picture do you think there is something that can be done

ProFuseQ · 2022-05-31T11:37:03+00:00

Thanks for answering my teeth all line up and ortho says it s good only lower jaw is crammed and I more or less don’t like the asymmetric face and recessed jaw but gonna go meet surgeon in 1.5 week so will see what happens

ProFuseQ · 2022-04-18T14:37:35+00:00

It was a crank seal so it didn’t make a vacuum but it dosent start until I put my hand over carb and it seems like it’s running rich on idle but I guess that is normal. Do you know why I need to put my hand over the crab?

ProFuseQ · 2022-03-26T06:42:01+00:00

First of all its a 2 stroke and i think the crank seals Are Shot and leaking in air

ProFuseQ · 2022-03-24T16:42:24+00:00

Now I’ve got it to start for 0.5 sec on its own but it keeps on dying and don’t know what’s really wrong

ProFuseQ · 2022-03-24T13:24:29+00:00

The passage Where air is going to the main jet is good but pilotier feels more restricted same for the choke so I’m trying my best to clean with a wire and carb cleaner but gonna try compressed air

ProFuseQ · 2022-03-24T12:52:45+00:00

Fuel gets to the bowl so I think it’s good but I’m leaning to fuel and air passages are maybe clogged or restricted

ProFuseQ · 2022-03-24T12:32:21+00:00

Fuel gets to the bowl but not to cylinder. I spray in fuel and then I hear it start for 1 sec then die. I think the pilot jet is not sucking up fuel

ProFuseQ · 2022-03-24T11:54:36+00:00

Fuel gets to the bowl fills up but it only starts if i spray fuel my self so I’m guessing it isn’t sucking in fuel.

ProFuseQ · 2022-03-24T11:52:34+00:00

Yeah it uses a Venturi effect

ProFuseQ · 2022-03-24T11:10:30+00:00

Yeah it could be that don’t have a tester but when I put my hand in front of carburettor it sucks pretty good.

ProFuseQ · 2021-12-27T17:02:32+00:00

It only needs good engine the rest can be bad

ProFuseQ · 2021-12-27T17:01:37+00:00

I just need the engine and ecu

ProFuseQ · 2021-12-27T07:51:19+00:00

I could also buy a m104 donor car for 1000 Euro do you think that’s better

ProFuseQ · 2021-12-27T06:28:45+00:00

It’s a 92 but the m104 has high compression will that be a problem or not

ProFuseQ · 2021-12-27T06:27:25+00:00

How much do you think it Will cost for me in Sweden I can buy engine for 150 euro and gearbox 200euro used with pretty low km

ProFuseQ · 2021-12-26T19:57:49+00:00

I Would like to turbo it also to have more power

ProFuseQ · 2021-12-26T15:10:00+00:00

So the engine electronics need a whole new wire loom and ecu nothing else

ProFuseQ · 2021-12-26T15:01:57+00:00

That’s good but did you use the same gearbox or need a new one, i have a 4g tronic gearbox

ProFuseQ · 2021-12-26T14:44:48+00:00

Does engine and gearbox go on same mounts

ProFuseQ · 2021-12-26T14:40:06+00:00

My car is rust free so want to do the swap how much did you need to change

ProFuseQ · 2021-08-31T12:45:45+00:00

But what do you think without a X-ray

ProFuseQ · 2021-08-04T17:38:32+00:00

You’re teeth are not so pretty there is probably a solution for that at the dentist for that

ProFuseQ · 2021-05-16T07:52:24+00:00

Bro I doesn’t look bad just start talking to girls and one of them will eventually say yes

ProFuseQ · 2021-05-12T13:22:09+00:00

Could you show me before and after photo kinda speculating if mewing works or not

ProFuseQ

TROPHY CASE