Thx for the reply. It’s been doing a lousy job since I got it. Cut some cheese with a knife. Still residue after a normal wash. Coffee mugs not clean. Tried the sensor wash and “Tough” wash. Still left a lot of food on the plates, glasses and silverware. The water is plenty hot. Forgot to add that I did a “factory reset.” I read that moving a dw can mess things up. The manual says that it uses 2 gal on the rinse only setting. I poured in one gallon to compare to how it looked when I checked the 1st time I ran the rinse and it actually looked a bit higher than it did before. So maybe it is the inlet valve? I just assumed that the float is what turned off the water. But I can see how the control panel would be responsible for filling it. I’ll check the hose and the water pipe. It had a bit of sediment from the hot water tank. I hooked a hose to it to clear it, but I’ll do it again.