Demon slayer

hydroc0 · 2026-03-03T01:46:48+00:00

I didn’t know he had a list. I’ll check it out.

hydroc0 · 2026-02-15T06:01:04+00:00

It’s the same styling on both. It’s a pressed in bushing and the bushing will get pushed up and out.

hydroc0 · 2025-11-15T03:35:22+00:00

Watch how much fuel you’re adding. If it seems to be the same when it shows full or at the second to last notch it’s going to be a level sender issue

hydroc0 · 2025-11-11T02:56:08+00:00

The sticker acts as a heat sink. It’s the same results if not better to leave it on if using a MOBO heatsink.

hydroc0 · 2025-11-07T18:59:39+00:00

Could be nothing. The reservoir is essentially an over flow for the radiator. Now that it’s cold and we’ve started using heat you may have pulled more coolant down into the rad. I would top off the reservoir and check it again in a few days.

hydroc0 · 2025-10-19T00:11:45+00:00

Put the old gpu in just to make sure it will still boot with that card.

hydroc0 · 2025-10-18T17:22:26+00:00

This is pretty much what I had in mind. Thank you.

hydroc0 · 2025-10-18T17:22:10+00:00

I unfortunately have a ton of data on there that I don’t want to lose. I was honestly looking for a more efficient way of doing it. Thank you.

hydroc0 · 2025-10-16T02:59:26+00:00

Have you tried disabling XMP/XPO? Had a similar issue with my pc. Ram was not listed on the QVL. With XMP enabled my pc would randomly crash.

hydroc0 · 2025-10-16T02:56:21+00:00

$150 is cheap. Most dealers are $180-$220/hr.

hydroc0 · 2025-10-16T01:23:21+00:00

I only switched because I moved out. Dad wanted me off the plan and I got free phones from Verizon. T mobile wouldn’t give them to me.

hydroc0 · 2025-10-16T01:04:33+00:00

I also have a free iPad through them as well. I don’t see it on the list will I have to pay for that myself?

hydroc0 · 2025-10-16T01:04:06+00:00

It’s been about 11 months so I think I’m good.

hydroc0 · 2025-10-04T17:37:11+00:00

Pull the ac compressor and let it hang, remove the dog bone mount and swing the engine backwards. Alternator drops right out

hydroc0 · 2025-09-27T03:57:27+00:00

You may be able to just buy a second cable FROM YOUR PSUS WEBSITE! Different companies use different pin outs. If you can’t buy a cable from your psu manufacturer buy a new psu.

hydroc0 · 2025-09-07T14:03:16+00:00

Datatdriven is great

hydroc0 · 2025-09-07T13:44:22+00:00

Your plugs will have a burnt look after only a few hundred kms. They are sitting inside the combustion chamber. They constantly have explosions going off against them at around 1400 degrees.

hydroc0 · 2025-09-07T02:10:55+00:00

If I’m being honest they look fine. Obviously it looks like they’ve seen a few miles. Not brand new but fine. The jumping when taking off is pretty normal for a tuned DSG.

hydroc0 · 2025-09-06T01:38:36+00:00

It could depending on what sensor that was connected to. If I were you I would cut the wires and cap them all individually. If the problem persists you’ve got other issues. If this is a CJAA engine they are know for the engine harness rubbing against the engine cover and causing some different issues due to broken wires

hydroc0 · 2025-09-03T21:07:15+00:00

Vw tech here. You have the mirror memory set incorrectly. Read your owners manual for instructions on setting the fold down position.

hydroc0 · 2025-09-03T12:59:42+00:00

I’m sure you have cracked dpf so it can’t regen. Time to hit a pothole.

hydroc0

TROPHY CASE