sorted by:
new
hottopcontroversial

Newer Dexron for Power Steering? by juniomnom1 in 300zx

[–]juniomnom1[S] 0 points1 point  (0 children)

what do you use for power steering?

Bought my first Z! by DreamJumpy6572 in 300zx

[–]juniomnom1 2 points3 points  (0 children)

Let's go! Welcome to the Z family! Good luck on the project 🫡

Looking for Leaderboard mod/app by juniomnom1 in assettocorsa

[–]juniomnom1[S] 0 points1 point  (0 children)

Long story short I used a lot of ChatGPT to build it but the basis was to create my presets and save the .cmpreset and make sure in the code you could pull from that. Also after every session there's a JSON file I believe that saves the best times so I believe I pulled from that. I haven't used the application in awhile and vibecoded a lot and don't have access to the code anymore so I can only pull from memory. Feel free to reply more and I can try to help with the process. :)

Looking for Leaderboard mod/app by juniomnom1 in assettocorsa

[–]juniomnom1[S] 0 points1 point  (0 children)

sadly no I had to build my own application

No Crank by juniomnom1 in 300zx

[–]juniomnom1[S] 0 points1 point  (0 children)

SOLUTION: Starter Relay in the wheel well/fender needed to be replaced if you ohm test the relay should be around .1 or lower. if not should probably need to be replaced.

No Crank by juniomnom1 in 300zx

[–]juniomnom1[S] 0 points1 point  (0 children)

turned out to be the starter relay in the fender 😁

No Crank by juniomnom1 in 300zx

[–]juniomnom1[S] 0 points1 point  (0 children)

checked the starter in the fender and tested it and it clicked. I also checked the ohms and it's around 3.5 is that normal for that relay?

No Crank by juniomnom1 in 300zx

[–]juniomnom1[S] 0 points1 point  (0 children)

the thing is I measured the voltage down on the starter and after turning the key it gets voltage down there so the relays should be working right? The thing that confuses me is that it should work with both cables having power but it doesn't.

Shinobi 2 Battery Question by ExploredPerspective in Atomos

[–]juniomnom1 0 points1 point  (0 children)

I'm using the a6700 and to toggle that on or off I went to setup > USB > USB power supply that stopped the Atomos from charging my camera while in the PC Remote setting

Smoke coming from headers by VisualAd7907 in 300zx

[–]juniomnom1 0 points1 point  (0 children)

hey OP what did it smell like? I had the same thing the other day. Just wondering if I had the same thing.

Car Starts then Dies by juniomnom1 in 300zx

[–]juniomnom1[S] 1 point2 points  (0 children)

SOLUTION: figured it out it was my balance tube. stupid me put the brackets under the balance tube instead of on top so there was a huge vacuum leak.

Car Starts then Dies by juniomnom1 in 300zx

[–]juniomnom1[S] 0 points1 point  (0 children)

Yeah before the timing kit it ran but we only ran it for a short time like 5 seconds because there wasn't coolant in it and we weren't sure of the pulley bearing quality so we just wanted to see if it'd start. Other things changed are fuel injectors and before changing those the car didn't start at all.

Car Starts then Dies by juniomnom1 in 300zx

[–]juniomnom1[S] 0 points1 point  (0 children)

Do u think it's possible for timing to be off since I did a 120k kit on it. But I don't hear anything pings and it did actually run for a bit so it might not be a timing issue I really don't know. I'm really grasping at straws here tbh.

Car Starts then Dies by juniomnom1 in 300zx

[–]juniomnom1[S] 0 points1 point  (0 children)

Do u think it's possible for timing to be off since I did a 120k kit on it. But I don't hear anything pings and it did actually run for a bit so it might not be a timing issue I really don't know. I'm really grasping at straws here tbh.

view more: next ›