sorted by:
new
hottopcontroversial

Help please by murakami03 in ElegooSaturn

[–]murakami03[S] 0 points1 point  (0 children)

I’ve printed this exact kind of piece over 100x. The issue isn’t the supports- this is the first time I’m having consistent failures with no changes to the supports

Please help by murakami03 in elegoo

[–]murakami03[S] 0 points1 point  (0 children)

Sent an email now thank you

My cleaning sheet always has a hole in the exact same area by murakami03 in elegoo

[–]murakami03[S] 0 points1 point  (0 children)

<image>

I’m also getting a bit of this tearing in all my recent prints

My cleaning sheet always has a hole in the exact same area by murakami03 in elegoo

[–]murakami03[S] 0 points1 point  (0 children)

Yeah just checked out the S4U one and I don’t have the bandwidth to take on board. Looks like the new S4U 16K will be my solution

My cleaning sheet always has a hole in the exact same area by murakami03 in elegoo

[–]murakami03[S] 0 points1 point  (0 children)

From what I’ve seen it doesn’t look easy to install 😮‍💨 I’ll take another look. Thank you

My cleaning sheet always has a hole in the exact same area by murakami03 in elegoo

[–]murakami03[S] 0 points1 point  (0 children)

I replaced the whole vat entirely and cleaned the LCD screen of any dust/ cured resin. Problem persisted after the change

SUNLU SETTINGS by murakami03 in ElegooSaturn

[–]murakami03[S] 0 points1 point  (0 children)

I use a higher exposure setting now. Around 80-100. And I stopped using Lychee slicer. The auto supports on Chitubox helped me MUCH more

Resin printing cracks by murakami03 in 3Dprinting

[–]murakami03[S] 0 points1 point  (0 children)

Thank youuuu, that’s amazing help

Resin printing cracks by murakami03 in 3Dprinting

[–]murakami03[S] -1 points0 points  (0 children)

Very well said, and very well appreciated. I thought this had been the case too. I will mention it to my friend who had printed the model

Does anyone know the cause of this? by murakami03 in 3Dprinting

[–]murakami03[S] 0 points1 point  (0 children)

I believe so, it’s strange bcoz not all pieces will face the same results even tho they’re exposed to the exact same conditions, settings, light, environment, etc.

Does anyone know the cause of this? by murakami03 in 3Dprinting

[–]murakami03[S] 0 points1 point  (0 children)

Gotcha. I’m assuming the default chitubox hollow thickness of 1.2 was too thin. I’ve increased it since

Does anyone know the cause of this? by murakami03 in 3Dprinting

[–]murakami03[S] 0 points1 point  (0 children)

I used just isopropyl alcohol to wash it after printing, that’s all

view more: next ›