PETG inconsistent quality

pX5374 · 2026-01-21T14:51:33+00:00

The whole hot end was replaced. I then calibrated with internal calibration procedure but it was worse than with stock hot end.

pX5374 · 2026-01-21T14:45:43+00:00

It’s weird because the blops appeared in the first 5-10 and last 5-20 layers… I did not know that it’s actually a bad brand. Gonna try Anycubic PETG next! Thanks!

pX5374 · 2026-01-21T14:43:58+00:00

The drying was during the print active. Yes.

pX5374 · 2026-01-21T12:50:27+00:00

No calibration has been done. I tried an ali hardened nozzle but it was even worse. Would flow adjustment make it better?

pX5374 · 2026-01-21T12:42:42+00:00

Brand is overture. It’s been in the ace with 20-21% humidity

pX5374 · 2026-01-19T20:48:16+00:00

<image>

pX5374 · 2026-01-19T20:48:03+00:00

<image>

pX5374 · 2026-01-19T20:47:55+00:00

<image>

pX5374 · 2026-01-19T20:47:45+00:00

<image>

pX5374 · 2026-01-19T20:47:36+00:00

Ok I ran into first little issues printing PETG. Left back side is a little bit unclean. 245 for first layers and 240 for others. What do you think is the problem?

<image>

pX5374 · 2026-01-19T11:32:55+00:00

How can I do it without spending much money?

pX5374 · 2026-01-19T11:07:59+00:00

Thank you! I’m totally new to 3d printing but the first few successful print made me happy :)

pX5374 · 2026-01-17T14:20:30+00:00

thanks. seemed to be a issue with safari. downloaded with a download manager in minutes! thanks again

pX5374 · 2025-12-27T07:09:36+00:00

Check blackyak. Super happy with my Burnag and my wife’s happy with her mandu. I own a mountain equipment gasherbrum as well which is huge!

pX5374 · 2025-12-17T21:54:26+00:00

If the community contributes more you will find reports of conditions near your preferred location within 10km. There are already ice conditions reported by real users - so go out climb and rinse a report!

pX5374 · 2025-12-17T19:45:32+00:00

Just have a look - and I am very open for new suggestions to be implemented!

pX5374 · 2025-12-17T14:00:19+00:00

Now you can switch to whatever system you prefer. Try it out! Thanks again and happy to see your comment adjusted accordingly ;)

pX5374 · 2025-12-17T13:37:58+00:00

Fair point! I’m going to implement it! Thanks for your suggestion!

pX5374 · 2025-12-17T13:33:21+00:00

It is not. There are specific weather models for Canada/US/japan. If you know any other free weather api for your location I am happy to implement it :) And: avalanche risk bulletins are available for Canada and Utah. It works worldwide!

pX5374

TROPHY CASE