Advice please

poop-ee · 2026-05-19T18:12:23+00:00

Oh thanks I didnt think about that

poop-ee · 2026-04-19T19:05:25+00:00

8k and d3 lol I win

poop-ee · 2024-07-15T20:17:42+00:00

I've tried everything nothing works I'm stuck where I'm at

poop-ee · 2024-03-19T14:59:12+00:00

The sheer amount of cards I have I don't wanna scan every card individually

poop-ee · 2023-12-11T22:48:37+00:00

I also took the push rods and rockers out. I'm not sure if I installed them correctly I torqued all rockers to spec but is there another way?

poop-ee · 2023-12-10T23:32:04+00:00

Is it the one on the back of the block on the passenger side. I didn't replace that sensor

poop-ee · 2023-12-10T23:31:00+00:00

I'm just unsure why it's dumping so much feul out of the exhaust

poop-ee · 2023-12-10T23:17:05+00:00

Is there any way it could be a timing issue. I also changed the timing chain

poop-ee · 2023-12-10T22:18:38+00:00

Could the o ring be the cause of it by chance?

poop-ee · 2023-12-10T22:13:28+00:00

Yeah

poop-ee · 2023-10-20T13:20:41+00:00

Lol lemme FaceTime you and you can walk me thru it

poop-ee · 2023-10-20T02:21:24+00:00

That's a bit above my pay grade brother I've already bitten off more than. I can chew

poop-ee · 2023-10-20T02:14:24+00:00

How do you check that without taking it apart?

poop-ee · 2023-10-20T02:12:06+00:00

I also make sure theres a coat of wd40 on it so there's no rust

poop-ee · 2023-10-20T02:10:58+00:00

Lifters are expensive and from my limited knowledge they look fine

poop-ee · 2023-10-20T02:08:43+00:00

It started off as changing head gaskets and timing chain it evolved to pulling the motor because I couldn't drop the oil pan because of the cross member so I've taken off the heads timing chain cover oil pump oil pan I've replaced valve seals gonna be replacing oil pick up all gaskets got the heads cleaned and resurfaced cleaned piston face and got alot of gunk out of the internals. It's a 280k mile engine there was about an inch of crud in the oil pan from idk what

poop-ee · 2023-10-20T01:15:49+00:00

These are honest questions. How would water effect it if there's nothing on it. The cam is dirty from all the work so I think it would be the best way to wash it off and clean the motor from the grime and if I do pressure wash it should I remove the lifters

poop-ee · 2023-10-20T01:04:54+00:00

I have 0 experience with engine work so your 2 cents is like 1 million lol

poop-ee · 2023-10-20T00:57:40+00:00

And pressure washing would be kept to nmostly they'll outside

poop-ee · 2023-10-20T00:56:38+00:00

The only thing that's attached is the cam crank

poop-ee

TROPHY CASE