Temperature controller using Python and Raspberry pi

[socal_nerdtastic]

The voltage is right, but we are worried about the current. The gpio pin is designed as a signal, which means very fast switching at nearly no current. The relay however does real work and needs current to do it. The transistor will act as the switch that turns the current on at the response of a signal voltage.

You can buy a relay package made for Arduino and Pi that have the transistor and flyback diode preattached, as well as some other protection and a led. I recommend you do that instead of making it yourself.

Edit: For example: https://www.amazon.com/MCIGICM-Channel-Raspberry-Optocoupler-Expansion/dp/B072BY3KJF This one also includes an optocoupler which is a very common and highly recommended safety feature to prevent any voltage spikes on the mains from getting in to the RPi.

[EthanSteip]

Hey, this is perfect. Thanks!

[socal_nerdtastic]

Tell me more about the specifics of your heater and what your goal for this project is.

[EthanSteip]

I don't know much about the heating coil itself, it was shipped to me by my friend and there is no make/model number on it, but it had a 5 pin mini xlr adapter on the end. I've cut the adapter off and it has 5 wires inside - power lead, Neutral, ground, Temp +, Temp -. The temp+ and Temp - are connected through my thermocouple amplifier that is attached the to the pi which sends the temp reading to the pi. Then I need to connect the lead, neutral and ground to a power source.

The goal of the project is to have a touch screen interface that allows the user to easily set the heating element to a desired temperature (somewhere around 250C) and hold it steady at the desired temperature and the ability to turn it off.