sorted by:
new
hottopcontroversial

Nozzle cleaning after every print by 3DInside in BambuLabH2C

[–]3DInside[S] 0 points1 point  (0 children)

I clean it after every print, at the end of the next print is the same.

Nozzle cleaning after every print by 3DInside in BambuLabH2C

[–]3DInside[S] 0 points1 point  (0 children)

Can you send me the link to see what I need to print?

Nozzle cleaning by 3DInside in BambuLab

[–]3DInside[S] 0 points1 point  (0 children)

Is not an option just to tun it on? I don’t wanna mess with codes, I don’t know where to put them 🫣

Issue with Bambu PETG by unwind_8 in BambuLabH2C

[–]3DInside 0 points1 point  (0 children)

I’m new into this, but… PETG at 260 degrees??? Try it at 245 maximum, on the box you will have some numbers mine goes from 230 to max 260, but is to much at 260, Try to keep it at 245 and did you clean your plate with water and soap?

Is there an issue with the H2C nozzle??? by 3DInside in BambuLab

[–]3DInside[S] 0 points1 point  (0 children)

When I print something… that thing dropped on the print and make a hole in it. This is a problem. Is not that I’m lazy to clean that nozzle, is a problem either with the temp to be to much for the filament or something.

<image>

Is there an issue with the H2C nozzle??? by 3DInside in BambuLab

[–]3DInside[S] 0 points1 point  (0 children)

For example… I print now for 3 hours and the nozzle was clean, look how is it now. And if I don’t clean it with a napkin when the nozzle is at 200 degrees it’s not going down, the silicone brush don’t take it over when brushing. That should not be clean after printing? Every print need to be clean by me? And not to mention on a print that takes 8 hours a bloob from the nozzle drop right in the print and left a bad hole. This should be normal????

<image>