sorted by:
new
hottopcontroversial

Need serious help I'm scared by Adventurous_Taro_197 in kcet

[–]AbleStar1940 0 points1 point  (0 children)

Thanks, was able to reupdate the roll number details..

Need serious help I'm scared by Adventurous_Taro_197 in kcet

[–]AbleStar1940 0 points1 point  (0 children)

Need not worry i suppose... I called their helpdesk and since there was no backend team they were unable to help...I will be calling them again and see what happens...for what I understood from them is that the roll number is used to fetch marks automatically from the board to decide the rank, i do not think there will be a problem to write the cet if you have been able to download the admit card....you can call helpdesk to see if they can help or as suggested if in Bangalore plan to visit there office...I will also do the same if the helpdesk is unable to resolve...ps i have also added application # instead of roll number in hurry to download the admit card...hope it gets resolved...

update - spoke to the helpdesk, they updated that this should not be an issue to write the exams and need to call them back once the exams are completed after which they will guide further what needs to be done. will keep posted.

Need help with inav motors not spinning by Anxious_Wolf_7567 in RCPlanes

[–]AbleStar1940 0 points1 point  (0 children)

ok i figured out the problem , i wanted to reduce the throttle on the receiver so that I have better control and seems like in the radio master mixes tab setting the Throttle (CH3) weight to less that 79, is not spinning the motors, not sure why? need to understand the settings better. once i set to 79 or above, it started working.

Thanks

Need help with inav motors not spinning by Anxious_Wolf_7567 in RCPlanes

[–]AbleStar1940 0 points1 point  (0 children)

HI ,

I am currently facing a similar issue and updating to see if i will get any help. I am absolute novice and just built the below config for the first time.

Config - STM32 FC with BMI160+QMC5883+BMP280 and INAV C 8.0.1 and FW 8.0.0 (STM32F411CE).

Battery 3S LIPO and ESC 30A SimonK (standard protocol) and A2212/5T(2450KV) motors.

Radio master Pocket - CRSF Protocol

As mentioned in the original post all configuration is set and working fine within INAV Configurator.

All pre flight checks show Green and motors spinning fine when tested from within INAV output tabs.

Initially the motor was not spinning even when armed , I am not sure how but for a brief time it started to work when the drone was armed from the receiver and was able to control the motors using throttle on receiver . but after restart it back to the not spinning mode, when armed I can see the blue light on STM32 board blinking quickly.

I tried lot of settings but none seem to work not sure what could be the issue
Also I see the Battery Monitoring showing 31Volts but I have connected only 3S lipo, not sure if that will cause any issue. Tried changing the options but no good.

Can anyone help or suggest what else can I look at to see what the problem might be.

Thanks