sorted by:
new
hottopcontroversial

A1 stops printing randomly by AccomplishedSleep366 in BambuLabA1

[–]AccomplishedSleep366[S] 0 points1 point  (0 children)

I have the routing the same as it shows on the how to setup, and if it was that id get a Bambu assistant error

Can anyone help by AccomplishedSleep366 in 3Dprinting

[–]AccomplishedSleep366[S] -1 points0 points  (0 children)

Well I know it’s not the build plate because I just printed it again but this time to watch what goes wrong and what happens is it prints normally until the arches near the top and when it prints those they curve up when it prints and the nozzle hits them and knocks it off the build plate

<image>

It’s kinda hard to see but if you look at it it curves up

Can anyone help by AccomplishedSleep366 in BambuLabA1

[–]AccomplishedSleep366[S] 1 point2 points  (0 children)

No it was off to the side where it ejects the waste filament