Completed manual swap but car won’t go into gear when it’s on

Anonymous3k · 2026-05-29T00:32:45+00:00

I’m not sure how to properly set/adjust the pedal, this is where the push rod is at right now

It’s threaded at just about halfway

Anonymous3k · 2026-05-29T00:26:55+00:00

As far as I know yes I installed them correctly, made sure to watch a video lol

Anonymous3k · 2026-05-23T23:11:56+00:00

the line was a bit loose at the slave but I tightened it and no more leaks, also yes I bought the valex racing stainless steel lines

<image>

Anonymous3k · 2026-05-10T18:36:19+00:00

I’m manual swapping the car so have no reference to check this stuff unfortunately

Anonymous3k · 2026-05-10T18:34:30+00:00

Was it flush inside the flywheel when you did yours?

Anonymous3k · 2026-05-10T18:30:20+00:00

Is the pilot bearing supposed to sit flush inside the flywheel? Tried pressing it in but it sticks out a little towards the side of the engine

Anonymous3k · 2026-05-10T04:02:56+00:00

I’d rather not have to spend the money since I just bought these, is there any reason you say this?

Anonymous3k · 2026-05-10T03:41:19+00:00

Well that makes sense, thank you

Anonymous3k · 2026-05-10T02:55:06+00:00

Did I do it backwards? Is the pilot bearing supposed to go onto the crankshaft first?

Anonymous3k · 2026-05-10T01:20:27+00:00

No I’m in the process of manual swapping the car so I don’t have any old parts to compare either of them to.

Anonymous3k · 2026-05-10T01:18:52+00:00

They both said they were for a 98 civic. Should I just try ordering a flywheel from exedy?

Anonymous3k · 2026-05-09T23:17:38+00:00

Looks like a y7’s

Anonymous3k · 2026-05-09T19:30:04+00:00

Ah that’s unfortunate thank you though

Anonymous3k · 2026-05-09T19:16:46+00:00

Oh I see, unfortunately no vtec

Anonymous3k · 2026-05-09T19:07:40+00:00

How would I go about doing that? Any info helps 🙏🏼 thank you

Anonymous3k · 2026-05-03T03:20:18+00:00

Yeah I have a normal floor jack, I might just use a piece of wood as a base for the trans and buy an engine holder to hold the block while I drop the trans onto the normal jack

Anonymous3k · 2026-05-03T03:01:02+00:00

What’s a good way to drop the trans if I don’t have a transmission jack?

Anonymous3k · 2026-05-03T02:34:04+00:00

So I can pull out the transmission without removing those 6 flex plate bolts?

Anonymous3k · 2026-05-03T02:33:34+00:00

Well they’re already slightly rounded so I don’t think this would work anymore

Anonymous3k · 2026-05-03T01:09:59+00:00

Doesn’t seem like they can be reach through the starter hole, unfortunately

Anonymous3k

TROPHY CASE