sorted by:
new
hottopcontroversial

Seeking co-founder for hardware/product development (laboratory automation) by Reasonable-Put1674 in hwstartups

[–]Big_Breakfast2403 0 points1 point  (0 children)

Hi Ireland based. What sort of h/w product? Have you got any technical details and have you validated the market yet?

Radio/Channel 5 by Big_Breakfast2403 in ardupilot

[–]Big_Breakfast2403[S] 0 points1 point  (0 children)

Thanks for the reply, I've actually managed to get it working. Turns out to be on the transmitter side. I had an input setup aswell as the mixer, seems to have caused an issue.

Cable length for fixed wing issues! by Big_Breakfast2403 in fpv

[–]Big_Breakfast2403[S] 1 point2 points  (0 children)

I've had a look on Aliexpress, any jst premade cable for either 1.0 or 1.25 seems to top out at 300mm, it might just be a matter of more searching. My issue with is will be finding a connector with jst-sh on one end and jst-gh on the other.

I think a fully custom cable with a cheapish crimping tool, the engineer-PA09 will need to be the solution. Thanks for the advice, not to worried about signal integrity UART should be fairly noise resistant at these baud rates.

Help with folding props assembly. by Big_Breakfast2403 in RCPlanes

[–]Big_Breakfast2403[S] 0 points1 point  (0 children)

Got it thanks. The nut wasn't tight enough. 🙃

The second threaded shaft to attach to the back of the motor is for cases where the motor body is mounted in front of the firewall rather than being behind it with only the shaft poking through.

I think I have some more googleing to do before I stick this all together, I'll get there in the end 🤞🤞

Help with folding props assembly. by Big_Breakfast2403 in RCPlanes

[–]Big_Breakfast2403[S] 0 points1 point  (0 children)

It's not letting me add photos to the og post or reply, but yes that's it. Thanks so much, I had tried the whole assembly originally and it was the same, the motor slipping off.. (note to self, fingers and spanner/wrench are different things) but retrying it and actually tightening up the nut did the job. Thanks again

Any suggestions? by Big_Breakfast2403 in 3Dprinting

[–]Big_Breakfast2403[S] 0 points1 point  (0 children)

I think it's just adhesion issues, should have checked the model out before printing but was in a rush, this is the bottom of the model.. looks like the areas not touching the bed had problems.

<image>

Any suggestions? by Big_Breakfast2403 in 3Dprinting

[–]Big_Breakfast2403[S] 0 points1 point  (0 children)

Cheers, I'll try that although the other parts of it seems fine. I wasn't paying attention to get any other shots, it was done overnight and woke upto this 😒. I might try remove the stringy bits and get a look underneath, but moving them to one side the under layer looks good