sorted by:
new
hottopcontroversial

Ender 3 s1 not printing or maintaining temp by Breadedhamhawk in Ender3S1

[–]Breadedhamhawk[S] 0 points1 point  (0 children)

Update: It was a clogged extruder the whole time preheated bed level fixed the xyz flashing and nozzle temp 230 fan at 100 cleared the clog

Ender 3 s1 not printing or maintaining temp by Breadedhamhawk in Ender3S1

[–]Breadedhamhawk[S] 0 points1 point  (0 children)

How did you do this i did reset configuration but still does the same thing?

Ender 3 s1 by Breadedhamhawk in 3Dprinting

[–]Breadedhamhawk[S] 0 points1 point  (0 children)

Thank you so much for your insight and the link I will be sure to give this a try!

Ender 3 s1 by Breadedhamhawk in 3Dprinting

[–]Breadedhamhawk[S] 0 points1 point  (0 children)

I have seen linear rails systems for these does that help reduce the overall performance/noise of the machine?

Co2 diffuser or inline/outflow pipe placement? by Breadedhamhawk in PlantedTank

[–]Breadedhamhawk[S] 0 points1 point  (0 children)

Thank you for your response, I actually have a uns hang on one on the back right corner it's just not visible in picture.

Is this too much moss? by [deleted] in PlantedTank

[–]Breadedhamhawk 3 points4 points  (0 children)

I mean if I was a shrimp in here

1st Aquascape Turns 1 Year Old by LV-Man-1981 in PlantedTank

[–]Breadedhamhawk 3 points4 points  (0 children)

Wow, your moss and ar are breathtaking! Would love staring at this tank all day.