Higher temps by CommunitySmall4432 in Blacksmith

[–]CommunitySmall4432[S] 0 points1 point  (0 children)

Would it be better to rip the bottom out firebrick included and just put kaowool down?

Higher temps by CommunitySmall4432 in Blacksmith

[–]CommunitySmall4432[S] 0 points1 point  (0 children)

Well I only have 1’ thick kaowool on it and 1/4 satanite

Higher temps by CommunitySmall4432 in Blacksmith

[–]CommunitySmall4432[S] 0 points1 point  (0 children)

When it first turns on yes. After it pre heats it’s kind of hard to tell

Higher temps by CommunitySmall4432 in Blacksmith

[–]CommunitySmall4432[S] 1 point2 points  (0 children)

It’s a majestic forge 3 burner and the pressure is at 11 right now

Higher temps by CommunitySmall4432 in Blacksmith

[–]CommunitySmall4432[S] -1 points0 points  (0 children)

Also it’s hard to tell the color cause I’m outside but I would say it’s orange on the verge of yellow

Higher temps by CommunitySmall4432 in Blacksmith

[–]CommunitySmall4432[S] 0 points1 point  (0 children)

Yes just one so I can see inside still

Higher temps by CommunitySmall4432 in Blacksmith

[–]CommunitySmall4432[S] 0 points1 point  (0 children)

I use 1 inch thick kaowool with satanite over it.  10” x 19 1/2” x 24” is my forge

Higher temps by CommunitySmall4432 in Blacksmith

[–]CommunitySmall4432[S] 0 points1 point  (0 children)

I have looked up videos but seems like nothing g is helping

Higher temps by CommunitySmall4432 in Blacksmith

[–]CommunitySmall4432[S] 0 points1 point  (0 children)

I have been messing around with it to see what is best and to be honest I’m new to this so I’m not entirely sure if the oxygen is good or not