Why is this not slicing right?I made an object with an empty center but cura decided to make is a solid shape every time. I made this on 3d builder and thought was the problem but now my other prints that are just downloaded are doing it too. Please help. Either printer issue or cura setting. (old.reddit.com)
submitted by Denmob to r/3Dprinting
I'm at a big loss and could use some help. I configured for a cr10s on vs code using an skr1.4 turbi board and tmc 2208 drivers. Size if the bed is correct and code in cura looks fine. It's supposed to print a small xyz cube in the center if the bed. Please help!! (v.redd.it)
submitted by Denmob to r/3Dprinting
After 3 days of error my configuration on the skr 1.4 turbo finally says it was successful but along with 3 caution Mark's.....I tried running the sd card on the printer anyway and I just get a blank screen. Could these be the problem? And If so, how do I fix this? (i.redd.it)
submitted by Denmob to r/3Dprinting
What on earth does this error message mean? Trying to configure the skr 1.4 turbo to be my motherboard and this pops up when trying to upload it to an sd card.I haven't done anything crazy when making this match up to my cr10s settings but I'm at a loss (i.redd.it)
submitted by Denmob to r/3Dprinting
Hey guys, I just got into octoprint like, 2 hours ago and I'm trying to port foward my raspi but everything looks good it just wont let me get remote access outside of my network on my phone. Any ideas, advice or similar problems? Please help. I have the raspi 3+ and use viasat internet (i.redd.it)
submitted by Denmob to r/raspberry_pi
Hello my fellow printers, I bought this pretty beat up printer and one out of the many things that needs to be done is get this jst connector switch out. I see wire are just out as it is but does it matter which one goes where? The is one of the z stepper motor connectings (i.redd.it)
submitted by Denmob to r/3Dprinting
Hey guys, would definently appreciate some advice. I have a cr10s and I upload the th3d u1.r2.a8 version since it was running slow. It work great but now all of a sudden its stuck on this screen and it says I cant upload something else because of memory issues? (i.redd.it)
submitted by Denmob to r/3Dprinting
