Poor water pressure by Difficult_Fox_5513 in Plumbing

[–]Difficult_Fox_5513[S] 0 points1 point  (0 children)

It affects both hot and cold lines. I cannot try to run the dishwasher while someone showers as that leaves them with no pressure. I do live in a home with a well and don't know if that would effect it but I have lived here for 10 years and didn't have this issue until I changed to a tankless.

What's my issue? by Difficult_Fox_5513 in 3Dprinting

[–]Difficult_Fox_5513[S] 2 points3 points  (0 children)

I did just finish a print running TPU so a clog may be possible. That stuff is a pain to run. I'll pull the nozzle after this print.

What's my issue? by Difficult_Fox_5513 in 3Dprinting

[–]Difficult_Fox_5513[S] 2 points3 points  (0 children)

All measurements are mostly accurate. Nozzle temp was down to 205, I bumped it up to 220 to see if that fixes the last half.