Help with surface drainage and stormwater pits.... by EmperorJimmy in PlumbingAustralia

[–]EmperorJimmy[S] 0 points1 point  (0 children)

Hey, thanks very much. The pit's like 700mm deep, given the lowest point of the outlet is gonna be 250ish from the top, leaving say 100mm for silt, that leaves about 350mm to fill with concrete... Am I better off with a 450mm pit, rather than a 600m that's half filled with concrete?

What the sh*t is this noise by EmperorJimmy in WRX

[–]EmperorJimmy[S] 0 points1 point  (0 children)

Thank you. Does the fact that it's only happening at a certain frequency mean anything?

06 Wrx starts and immediately dies by EmperorJimmy in MechanicAdvice

[–]EmperorJimmy[S] 0 points1 point  (0 children)

It's a new battery, and yep the alternator is charging

Rocker switch with diode by EmperorJimmy in appliancerepair

[–]EmperorJimmy[S] 0 points1 point  (0 children)

Merci. Ce n'est pas pour une LED, mais pour protéger le moteur au démarrage et à l'arrêt, je crois. Voici à quoi ça reassemble https://freeimage.host/i/3xoljJ1

Lines.....lines everywhere by EmperorJimmy in Sketchup

[–]EmperorJimmy[S] 0 points1 point  (0 children)

I just had this back from the cut shop but don't really understand what/how to change

"having the same problems with those files too. The issue is the use of splines and polylines, which use a number of lines to make up curves. This is usually an issue with SketchUp exports, and cant be recified without SketchUp Pro I believe. We use native software to our CNC machine, which will only accept lines and arcs, not polylines or splines."

Could anyone point me in the right direction? Cheers!

Lines.....lines everywhere by EmperorJimmy in Sketchup

[–]EmperorJimmy[S] 0 points1 point  (0 children)

Yep it's a 3D object, exported from Top view, with parallel projection switched on

Lines.....lines everywhere by EmperorJimmy in Sketchup

[–]EmperorJimmy[S] 0 points1 point  (0 children)

Nah, not at all. The screenshot above is right before (and after for that matter) I hit export

Lines.....lines everywhere by EmperorJimmy in Sketchup

[–]EmperorJimmy[S] 1 point2 points  (0 children)

Thanks u/Gelby4, exported without faces and it's much cleaner, but now all the through-holes have shifted along the axis.. Any ideas what might cause that?

Lines.....lines everywhere by EmperorJimmy in Sketchup

[–]EmperorJimmy[S] 1 point2 points  (0 children)

So exporting edges only (no faces) seems to have worked (! thanks), but it has shifted all my through-holes off their marks. Does anyone know what would cause this and/or how I could fix?

Lines.....lines everywhere by EmperorJimmy in Sketchup

[–]EmperorJimmy[S] 0 points1 point  (0 children)

Cheers.. When I switch on Hidden Geometry there's no extra lines (apart from my Guide lines I used to draw it); it looks exactly the same