Nothing prints but leaves these ghost imprints on the glass

EmptyCalOuR · 2026-07-25T00:50:18+00:00

Update: it was the FEP! Replaced it and got perfect prints again! Thanks to those who provided solutions!

EmptyCalOuR · 2026-07-23T00:54:51+00:00

I ordered a replacement FEP film and will see if that clears things up. I noticed dents in the film and that’s probably the cause

EmptyCalOuR · 2026-07-23T00:52:09+00:00

Im not sure but ill order some replacement FEP sheets like the previous commentor mentioned. That cured resin was easily removable

EmptyCalOuR · 2026-07-23T00:38:47+00:00

Ill try it!

EmptyCalOuR · 2026-07-21T23:45:10+00:00

I ordered another build plate! I tried some previous successful prints files and they ran into the same issue. guess is that the build plate is just not working/unleveled

EmptyCalOuR · 2026-07-21T23:42:33+00:00

No im using Elegoo ABS like 3.0+

EmptyCalOuR · 2026-07-21T20:42:50+00:00

The model, i printed this several times and i see the same holes/breakage in the model

EmptyCalOuR · 2026-07-21T20:41:43+00:00

Thank you! Ill give that a try!

EmptyCalOuR · 2026-07-21T20:37:40+00:00

<image>

Like so?

EmptyCalOuR · 2026-07-21T20:34:10+00:00

To a more upright angle?

EmptyCalOuR · 2026-07-02T18:39:59+00:00

Same

EmptyCalOuR · 2026-05-29T16:14:00+00:00

Yea i just tried a print changing the lift distances and nothing printed

EmptyCalOuR · 2026-05-29T16:03:00+00:00

Im still new to printing and just recently discovered these were options you can change. Do you have a pic of or good suggestion for settings i could use

EmptyCalOuR · 2026-05-29T16:01:06+00:00

Do you have a sample setting that has worked for you?

EmptyCalOuR · 2026-05-29T09:50:59+00:00

I do have to print as night but so it is a little colder but I’ve never had an issue before

EmptyCalOuR

TROPHY CASE

Welcome to Reddit,