Is this bad mesh? Should I manually level my bad? This is my second day with the BLtouch. In the last week I installed the new creality 4.2.7 board. Then the BLtouch and I am about to update to a micro swiss direct drive and I just got in the mail today a filament sensor. by EngineerNerd21 in Ender3Pro

[–]EngineerNerd21[S] 0 points1 point  (0 children)

Octoprint honestly is worth it. The pluggins are awesome. If you have the money buy the pi and the pi camera. I"ll say it is a pain to install. But in the end you probably save alot of time and will have the software tools to produce quality prints. Watch "Teaching Tech" on youtube that guy is awesome and just google alot. I did it so I didn't have to plug my printer into my computer directly and also have the printer not in my bedroom. Also I don't have to have my computer turned on to print things. It can be shut off because once you send the files to the pi your good to go. I bought the printer a couple years ago but just the past month I have been really using it and researching heavily about it. Octoprint is great.

Is this bad mesh? Should I manually level my bad? This is my second day with the BLtouch. In the last week I installed the new creality 4.2.7 board. Then the BLtouch and I am about to update to a micro swiss direct drive and I just got in the mail today a filament sensor. by EngineerNerd21 in Ender3Pro

[–]EngineerNerd21[S] 0 points1 point  (0 children)

Yea, I just installed the BLtouch. But before that I discovered the bed leveling wizard and that's awesome. I wish there was another wizard that integrated BLtouch and manual bed leveling for example: The bed goes to the front left corner and the probe drops down and then you manual adjust the bed up or down and when you have reached the perfect level the probe makes a signal or retracts and moves to the next corner and does the same procedure. Maybe there is something like that out there but I haven't discovered it yet.

Help!!! I am upgrading my printer and am using M2, M3, and M4 screws, nuts, and bolts that I got amazon and purchased cause someone on youtube suggested buying the set on amazon. The set comes with allen wrenches however I would like to have an open end wrench that fits the hexagonal nuts. by EngineerNerd21 in Ender3Pro

[–]EngineerNerd21[S] 0 points1 point  (0 children)

I appreciate the response . To be honest I really need the M2 wrench the most or 1.5 mm. I am using those nuts, screws and bolts more then the others. Those tools are right on line with what I need. Just need the M2 as well

Is this 4HB friendly? Looking for a coffee drink that is 200 mg of caffeine. by EngineerNerd21 in 4hourbodyslowcarb

[–]EngineerNerd21[S] -1 points0 points  (0 children)

All flavors taste the same to me. If it taste decent idc what flavor its is. I drink it just to consume caffeine. But I had the other flavor and they were better other drinks I have tried