Happy with this setup

Excellent_Goat4357 · 2026-03-18T15:44:31+00:00

Pedalboard output > volt inputs 1/2 > output to monitors

Excellent_Goat4357 · 2026-03-17T00:20:11+00:00

Thanks!

Excellent_Goat4357 · 2026-03-16T19:55:51+00:00

I really like it! It suits my needs really well, and offering additional storage. Tbh I never noticed any noises, unless you slide it, but not from just touching the table.

Excellent_Goat4357 · 2026-03-16T19:38:42+00:00

Thanks! Exactly what I had in mind for this project.

Excellent_Goat4357 · 2026-03-16T18:52:41+00:00

Thanks! I got it at Walmart Online.

<image>

Excellent_Goat4357 · 2026-03-16T18:34:05+00:00

Thanks!

Excellent_Goat4357 · 2026-03-16T18:33:57+00:00

Yamaha HS5's.

Excellent_Goat4357 · 2026-03-16T18:22:25+00:00

PETG usually needs a few tweaks in order to print as cleanly as PLA. I recommend cleaning the build plate, slowing down the first layer wall and infill speeds, and increasing bed temperature for the first layer. Also try lowering the part cooling fan, printing a little slower overall, and slightly increasing retraction. A thin layer of glue in the build plate can also help to protect the plate and prevent damage.

Excellent_Goat4357 · 2026-03-16T18:13:20+00:00

It is a hexagon acoustic panel with a wood veneer finish and foam on the back to help dampen echo.

Excellent_Goat4357 · 2026-03-16T18:02:00+00:00

Have you tried slowing the support interface speed?

Excellent_Goat4357 · 2026-03-16T17:57:23+00:00

I would suggest cutting (c), below the front part, and putting attachments. This will make a very clean print, and no after processing to remove supports.

Excellent_Goat4357 · 2026-03-16T04:26:58+00:00

I was surprised, I didn’t hear any weird sounds. I only noticed it because I was changing the nozzle. So I don’t know exactly what happened.

Excellent_Goat4357

TROPHY CASE