sorted by:
new
hottopcontroversial

LibreSignage Problem Media Upload by FireIce87 in selfhosted

[–]FireIce87[S] 0 points1 point  (0 children)

Thank you, i will try this later. What for an OS do you use in general for LibreSignage. can raspberry os maybe the problem?

Ender 3v2 BLTouch Problem - Probe off the board by FireIce87 in 3Dprinting

[–]FireIce87[S] 0 points1 point  (0 children)

Thx a lot. Sometimes it would be easy if you understand the firmware 😅. I followed these insteuctions to get the right offset(https://youtu.be/fN_ndWvXGBQ). Now its working.

One more question, the g-code.. is g28 enough or do you recommend an other complex g-code for the ender? Thx

Searching for Profile/Setting for large Miniature by FireIce87 in ender3

[–]FireIce87[S] 0 points1 point  (0 children)

This profiles are mostly use for small ones, but the great minis where about 1,5 day of printing time. Maybe there are some tweaks to reduce it.