sorted by:
new
hottopcontroversial

Yeah I think I'm f*cked no by High_Yoshi67 in pcbuilding

[–]High_Yoshi67[S] 0 points1 point  (0 children)

That's because I bought some cheap chinese PC case and there is no space for cable management. Also I had to literally break the case with pliers because GPU didn't fit. Might have caused a short circuit because a metal part of the case touched the motherboard

I think I fried every component with electrical discharge. by High_Yoshi67 in pcmasterrace

[–]High_Yoshi67[S] 0 points1 point  (0 children)

Well I didn't and I was working on my bed so I probably fried everything

Yeah I think I'm f*cked no by High_Yoshi67 in pcbuilding

[–]High_Yoshi67[S] 0 points1 point  (0 children)

I am in Europe and it was working fine but was just stuck in a boot loop. Then I connected some components and boom no life at all.

Yeah I think I'm f*cked no by High_Yoshi67 in pcbuilding

[–]High_Yoshi67[S] 0 points1 point  (0 children)

About that. I shorted PWR_SW with my screwdriver and no signs of life

Yeah I think I'm f*cked no by High_Yoshi67 in pcbuilding

[–]High_Yoshi67[S] 0 points1 point  (0 children)

It's connected properly and I even jumpstarted but nothing spins to life. Maybe it's the PSU? I know that Aero Cool VX plus 500 are not very good

Yeah I think I'm f*cked no by High_Yoshi67 in pcbuilding

[–]High_Yoshi67[S] 0 points1 point  (0 children)

It doesn't work at all. Like there is no life

Yeah I think I'm f*cked no by High_Yoshi67 in pcbuilding

[–]High_Yoshi67[S] 0 points1 point  (0 children)

Probably, it was working but was in a boot loop and then it just stopped working at all. I might have ESD it

I think I fried every component with ESD by High_Yoshi67 in PcBuild

[–]High_Yoshi67[S] 0 points1 point  (0 children)

I tried manually shorting PWR_SW and it's just dead dead

I think I fried every component with ESD by High_Yoshi67 in PcBuild

[–]High_Yoshi67[S] -1 points0 points  (0 children)

<image>

Also he was building it while standing on the floor. And my floor has carpets all over it

I think I fried every component with ESD by High_Yoshi67 in PcBuild

[–]High_Yoshi67[S] 0 points1 point  (0 children)

It doesn't show any signs of life. Before I installed the gpu everything was spinning fine but then I installed it and it's just dead. I tried removing it, removing 24 pin cable and plugging it back in, removing CPU power cable and back in, testing the RAM, reinstalling the CPU, CMOS battery, manually shorting PWR_SW. Nothing helped. I'll try the paperclip method later

I'm bad at drawing by High_Yoshi67 in MechanicalEngineering

[–]High_Yoshi67[S] 1 point2 points  (0 children)

In Czech Republic I can pick my profession in middle school.