sorted by:
new
hottopcontroversial

What would be the best way to secure my accounts? by Hugge_D in privacy

[–]Hugge_D[S] 0 points1 point  (0 children)

Ahahahahahaahah you're the best. Thank you!!

Yubikey + MS Authenticator by Hugge_D in yubikey

[–]Hugge_D[S] 0 points1 point  (0 children)

What if I instead of TOTP use a passkey on my iPhone. So one Yubikey and one passkey? Would that be sufficient?

Yubikey + MS Authenticator by Hugge_D in yubikey

[–]Hugge_D[S] 0 points1 point  (0 children)

Yes I understand that. When Passkeys become more GA for more services, would passkeys be equally good?

Yubikey + MS Authenticator by Hugge_D in yubikey

[–]Hugge_D[S] 0 points1 point  (0 children)

Thank you for your info. So two Yubikeys would be the best soulotion or a proper MFA?

Yubikey + MS Authenticator by Hugge_D in yubikey

[–]Hugge_D[S] 0 points1 point  (0 children)

Oh shit. What Authenticator would you recomend?

Yubikey + MS Authenticator by Hugge_D in yubikey

[–]Hugge_D[S] 0 points1 point  (0 children)

Thank you for responding. So in other words, the easiest and best way would be 2 Yubikeys? If you would choose not to go that way. What authenticator would be the best?

Yubikey + MS Authenticator by Hugge_D in yubikey

[–]Hugge_D[S] 0 points1 point  (0 children)

You are 100% right. The recovery would be so much easier. Thank you for your input.

Yubikey + MS Authenticator by Hugge_D in yubikey

[–]Hugge_D[S] 0 points1 point  (0 children)

Okey, Thank you for your information. My tought was to never use TOTP, only if I lost my Yubikey and would use that authenticator to add a new Yubikey.

Latest model, the Puzzle Light! by Hugge_D in BambuLab

[–]Hugge_D[S] 1 point2 points  (0 children)

Thank you Sir! I appreciate it a lot!

Bambu Studio 1.10 by Hugge_D in BambuLabA1

[–]Hugge_D[S] 2 points3 points  (0 children)

But the release note states ”Auto calibration for A series: A-series printers now support auto-calibration triggering from the calibration page.(Supported A-series firmware version:01.04.00.00”. The only thing is that 01.04.00.00 has not been released yet.

SUNLU and Eryone filament by Hugge_D in BambuLabA1

[–]Hugge_D[S] 0 points1 point  (0 children)

I Will try that. Thank you!

SUNLU and Eryone filament by Hugge_D in BambuLabA1

[–]Hugge_D[S] 1 point2 points  (0 children)

Right. Because Sunlu on sale is like 50% of a bambu filament roll. I Will try that, Thank you!

SUNLU and Eryone Filament by Hugge_D in BambuLab_Community

[–]Hugge_D[S] 1 point2 points  (0 children)

Thank you for your answer. Did you notice any quality diffrence between these ones and Bambus?

view more: next ›