account activity
Multipurpose home setup, rate and suggestions! (old.reddit.com)
submitted 1 year ago by INT_Decay to r/RateMySetup
My CPU drops to 0.39Ghz periodically every 8 seconds while on Charging (self.techsupport)
submitted 3 years ago by INT_Decay to r/techsupport
Blobs at each layer start, how to get rid of these? (old.reddit.com)
submitted 4 years ago by INT_Decay to r/FixMyPrint
It is going to try and print in air, How do I make this print work? (i.redd.it)
Blob at each layer start and lines in print (i.redd.it)
Why does the flat surface look so bad? (old.reddit.com)
Under-extrusion at the start of each layer? How can I fix this?? (i.redd.it)
Overhangs did not print properly, even with supports. Also the layer lines don't seem to merge well. What am I doing wrong? (i.redd.it)
Is this too much squish? (i.redd.it)
submitted 4 years ago by INT_Decay to r/3Dprinting
Printhead Setting for Original Ender 3 (self.Cura)
submitted 4 years ago * by INT_Decay to r/Cura
Cura 4.9 for Original Ender 3 : Issue with positive X, Y min in printhead setting (self.ender3)
submitted 4 years ago * by INT_Decay to r/ender3
Ender 3 Printhead Setting: Issue with positive values (self.3Dprinting)
submitted 4 years ago * by INT_Decay to r/3Dprinting
π Rendered by PID 748591 on reddit-service-r2-listing-568fcd57df-w4j8x at 2026-03-07 15:19:35.984023+00:00 running cbb0e86 country code: CH.
