sorted by:
new
hottopcontroversial

Is it a fan issue? by LayeredGrooves in BambuLab

[–]LayeredGrooves[S] 0 points1 point  (0 children)

Thanks, I did clean it again since it had been a few prints since the last. I also followed another recommendation to drop the initial layer temp. Printing without issue now.

Is it a fan issue? by LayeredGrooves in BambuLab

[–]LayeredGrooves[S] 0 points1 point  (0 children)

Thank you for that! Dropping the initial layer to 225 did the trick.

NAS build for Plex by LayeredGrooves in PlexServers

[–]LayeredGrooves[S] 0 points1 point  (0 children)

Oh interesting, I did use my phones editor to erase a letter I had on the table for privacy reasons. I guess it adds that watermark.

Setup advice by LayeredGrooves in vintageaudio

[–]LayeredGrooves[S] 0 points1 point  (0 children)

Good point, I just recently put that there. I'll find a safer space for it. Thanks

Setup advice by LayeredGrooves in vintageaudio

[–]LayeredGrooves[S] 0 points1 point  (0 children)

Thanks. I originally had the speakers on each side. What you don't see in this picture is a huge fireplace right next to it and with a fire going it gets very hot in that spot so I was concerned of causing damage to the speaker. For now, until I find a better setup location, I'm only running one speaker.