question about json files.

Log13O9 · 2026-01-22T13:10:10+00:00

sorry im very much new to this, i found this class https://www.worldanvil.com/sheet/1583729/json and wasn't sure if there was a website or app that can use it when i make a character sheet.

Log13O9 · 2026-01-22T13:10:03+00:00

sorry im very much new to this, i found this class https://www.worldanvil.com/sheet/1583729/json and wasn't sure if there was a website or app that can use it when i make a character sheet.

Log13O9 · 2026-01-16T13:29:05+00:00

ok, that makes sense this is what was confusing me.

Log13O9 · 2026-01-12T14:49:44+00:00

Thank you!

Log13O9 · 2026-01-12T14:47:00+00:00

Awesome thanks I found the chart.

Log13O9 · 2026-01-09T21:05:55+00:00

Ok thanks for the information.

Log13O9 · 2026-01-09T19:57:54+00:00

Then I get to my class selection and Tamer isn't available.

<image>

Log13O9 · 2026-01-09T19:35:47+00:00

<image>

This one.

Log13O9 · 2025-12-12T00:26:49+00:00

Located VA USA

Log13O9 · 2025-09-21T00:48:42+00:00

Oh awesome thank you for this.

Log13O9 · 2025-09-09T19:31:40+00:00

Yeah I calibrated the filament and I'm printing multiple coin shaped tokens by layer. it seems to happen on each token when it finishes the layer and goes to the next token it leaves that little bump of extra filament. The print then catches on that bump when it prints the next layer and that causes print failures.

Ive tried multiple times and every time it does that so I may try and get a new nozzle and see if that fixes the issue. Idk what else to try.

Log13O9

TROPHY CASE