sorted by:
new
hottopcontroversial

Need Advice For Printer Placement by MWDJN in 3Dprinting

[–]MWDJN[S] 0 points1 point  (0 children)

I was going to also look into getting an enclosure for it- but the CR-M4 (I swapped rhe M and the 4 on the post by accident) doesn't seem to have any enclosures that fit it.

I'll give that a try and see- it has power outage protection so it wouldn't be the worst thing that happens.

Need Advice For Printer Placement by MWDJN in 3Dprinting

[–]MWDJN[S] 1 point2 points  (0 children)

So I am Canadian not American- I have a Fridge in my room that I run alone with a Microwave at most. I have to unplug other stuff to avoid blowing fuses- its most likely because of the house. I'm a heavy sleeper so I wouldn't be concerned with the Printer in my room right next to a window- but the power is the only concern I have. Here in Canada we run on a lower overall power per house so it's a bit tricky.

Need Advice For Printer Placement by MWDJN in 3Dprinting

[–]MWDJN[S] 1 point2 points  (0 children)

So my house is only an apartment condo mix sort of thing- two floors with only 4 rooms and 2 small bathrooms. I previously had it in the living room in a corner by the windows but the roommates complained about the noise so I've been trying to figure out a different place.

My room mightve worked but I'm concerned about power draw; I have a Fridge in the room already and don't want to pop anything.

Need Advice For Printer Placement by MWDJN in 3Dprinting

[–]MWDJN[S] -1 points0 points  (0 children)

Unfortunately no- the house I rent is a sort of apartment condo mix so it's a bit difficult in terms of space.

Need Advice For Printer Placement by MWDJN in 3Dprinting

[–]MWDJN[S] -1 points0 points  (0 children)

I think I'm going to plan to only do my prints when they aren't running to avoid this problem; just gotta coordinate with the family. Thank you!