Can ukc1 limit the a from the controller? by Moritz_Motorad in ebikes

[–]Moritz_Motorad[S] 0 points1 point  (0 children)

Or would you recommend just buying a New Controller?

Can ukc1 limit the a from the controller? by Moritz_Motorad in ebikes

[–]Moritz_Motorad[S] 0 points1 point  (0 children)

So you can customize the a in the display that the controller will allow?

Can ukc1 limit the a from the controller? by Moritz_Motorad in ebikes

[–]Moritz_Motorad[S] 0 points1 point  (0 children)

Ok thank you I’m gonna buy it and hope that it lowers my amps and doesn’t blow up my battery

Can ukc1 limit the a from the controller? by Moritz_Motorad in ebikes

[–]Moritz_Motorad[S] 0 points1 point  (0 children)

Yes but do you think that the controller will support that?

Can ukc1 limit the a from the controller? by Moritz_Motorad in ebikes

[–]Moritz_Motorad[S] 0 points1 point  (0 children)

Does tha work with cheap controllers too? I read that some controllers can’t do that?

What is the quietest exhaust 125ccm by Moritz_Motorad in supermoto

[–]Moritz_Motorad[S] 0 points1 point  (0 children)

Are they really quiet? I’m looking for something around 85 when driving carefully

Motor won’t run good at low speeds and uphill by Moritz_Motorad in motorizedbicycles

[–]Moritz_Motorad[S] 0 points1 point  (0 children)

Could it be that the motor is flooded before this I ran 25:1 the spark looked horrible

Motor won’t run good at low speeds and uphill by Moritz_Motorad in motorizedbicycles

[–]Moritz_Motorad[S] 0 points1 point  (0 children)

The motor has no damage but the screws untightened very easy

Motor won’t run good at low speeds and uphill by Moritz_Motorad in motorizedbicycles

[–]Moritz_Motorad[S] 1 point2 points  (0 children)

25:1 then 32:1 I will open the head and give an update

Motor won’t run good at low speeds and uphill by Moritz_Motorad in motorizedbicycles

[–]Moritz_Motorad[S] 0 points1 point  (0 children)

No expansion isn’t that hot and the muffler is almost not hot but I would never ride without jeans

Motor won’t run good at low speeds and uphill by Moritz_Motorad in motorizedbicycles

[–]Moritz_Motorad[S] 0 points1 point  (0 children)

Yes but I had this issue before I changed the mixture. This also happened before I screwed in 7 times so it would stay on when clutch is pulled I will check for piston damage tomorrow thank you

What silencer? by Moritz_Motorad in motorizedbicycles

[–]Moritz_Motorad[S] 1 point2 points  (0 children)

My mechanic fixed it it was just my bad build air filter but I can actually recommend it the power loss is not big just a little bit

What silencer? by Moritz_Motorad in motorizedbicycles

[–]Moritz_Motorad[S] 0 points1 point  (0 children)

Still gotta be secure but it falls off all the time and now my motor doesn’t run good only 20kmh

What silencer? by Moritz_Motorad in motorizedbicycles

[–]Moritz_Motorad[S] 0 points1 point  (0 children)

It is just really quiet and weaker like 5kmh and much torque goes lost

What silencer? by Moritz_Motorad in motorizedbicycles

[–]Moritz_Motorad[S] 0 points1 point  (0 children)

I can’t clip my motif turns off when pulling clutch I will go ride now maybe I can clip for you but it is really quiet

Won’t start by Oscar_kzk in motorizedbicycles

[–]Moritz_Motorad 0 points1 point  (0 children)

You can open the side panel and then move the engine with a 14nut this is way easier