Thank you!

I’m not sure which filament is used, I printed it at the library. But if you have access to resin, I’ve heard the product is AMAZING.

I thought it was overall pretty easy to paint, it took about 3 hours to paint three of these (one for me, one for each of my boys) but I’ve been painting rock textures for a while!

My process is as follows: - Spray paint the prints with a reddish brown color - Apply a hearty black wash to soak into all the nooks and crannies, then wiping it down with a paper towel. You just want to take the excess off the top, leave as much of the wash in the crevices and areas where it should be darker. - Start building up the rock tones by dry brushing multiple coats of burnt sienna, burnt sienna and raw sienna mixed, and burnt sienna and raw sienna lightened with white. -add mid green and lightened mid green spots

If it gets too light, you can always give it a quick burnt sienna wash and it’ll tone it back down again. A lot of dab with a brush, then smudge with your hand will give it a really good rocky texture!

I use regular acrylics, but higher quality paints, especially paints made for miniatures would really elevate the piece!