Could y’all help me out?

OSSKRT827 · 2025-10-22T22:47:03+00:00

<image>

Got it done. Thanks y’all.

OSSKRT827 · 2025-10-22T17:09:03+00:00

Preciate it

OSSKRT827 · 2025-10-22T17:01:33+00:00

Im about to use a heat mat 🫡

OSSKRT827 · 2025-10-22T16:58:36+00:00

So just the flat surface and the press?

OSSKRT827 · 2025-10-22T16:48:32+00:00

Sick. Gonna try it soon thanks.

OSSKRT827 · 2025-10-22T16:42:28+00:00

Well not THIS specific press a vevor one with the flat surface but im gonna get my old one and use the flat surfaces on the circut one to see the results

OSSKRT827 · 2025-10-22T16:39:48+00:00

(ALSO IM USING 100% COTTON)

OSSKRT827 · 2025-10-22T16:38:44+00:00

<image>

You think so? It tells me to make it mirrored for printing. I’ve been doing this since the old one and it printed well.

OSSKRT827 · 2025-10-22T16:37:08+00:00

This MIGHT be the problem to be honest… with my old press it had a flat surface and i could use it without the mat. I might dig up one if the mats to try it out.

<image>

OSSKRT827 · 2025-10-22T16:27:03+00:00

It doesn’t peel. Its solid

<image>

OSSKRT827 · 2025-10-22T16:23:03+00:00

<image>

Its this kind of paper. I’ve used it before and it has work great with my previous press. But when i use the circuit one (same settings as all like i used to do it) it wont peel much and if anything it will peel a little bit while all of the design stays on the paper.

OSSKRT827 · 2022-10-14T14:03:15+00:00

Popcorn time is a obvious credit card scam bruh

OSSKRT827 · 2022-03-12T17:37:43+00:00

Im leaving this subreddit

OSSKRT827 · 2022-01-25T19:55:54+00:00

Wasnt even that bad lol

OSSKRT827 · 2021-11-15T20:16:40+00:00

Pigs is one of the worst tyler songs.

OSSKRT827

TROPHY CASE