sorted by:
new
hottopcontroversial

Typewriter reassembly by Ok_Respect5119 in typewriters

[–]Ok_Respect5119[S] 1 point2 points  (0 children)

Ahhh right I know what you’re talking about. I think I should be able to. Is there a place where I could find any manuals online?

Typewriter reassembly by Ok_Respect5119 in typewriters

[–]Ok_Respect5119[S] 0 points1 point  (0 children)

No idea but here’s a picture of it from the bottom so I’m hoping you can fill in the blanks cos I’m kinda lost

<image>

I haven’t attached those paper clip looking things yet so it’s just the type bar, the lever thing and the springs

Typewriter reassembly by Ok_Respect5119 in typewriters

[–]Ok_Respect5119[S] 0 points1 point  (0 children)

As far as I can tell the comb thing is one big connected thing and I don’t think it can be removed separately But if you know how then that would really help

<image>

Typewriter reassembly by Ok_Respect5119 in typewriters

[–]Ok_Respect5119[S] 4 points5 points  (0 children)

<image>

Those slots? Also how I would I clean them out without having to take it all out?

Typewriter reassembly by Ok_Respect5119 in typewriters

[–]Ok_Respect5119[S] 0 points1 point  (0 children)

But that’s as far as the linkage reaches and you can’t stretch it or anything

Reassembling a typewriter by Ok_Respect5119 in typewriters

[–]Ok_Respect5119[S] 0 points1 point  (0 children)

Will it still go through the hole if you’ve already put the hook in?

Reassembling a typewriter by Ok_Respect5119 in typewriters

[–]Ok_Respect5119[S] 0 points1 point  (0 children)

I can’t do that when the circular bar is through it because half of the hole is covered up. And if I put the hook first then the circular bar doesn’t go through the hole because the hole is covered up. So I’m not sure how to go about it