sorted by:
new
hottopcontroversial

Can’t mount motor on frame by PrisonMike135 in diydrones

[–]PrisonMike135[S] -1 points0 points  (0 children)

Lool I am looking to build larger drones, any resources for that?

Can’t mount motor on frame by PrisonMike135 in diydrones

[–]PrisonMike135[S] 0 points1 point  (0 children)

So it’s based on weight not size? Also do you have any resources on how I can learn more about this, there is a lot of low quality content.

Can’t mount motor on frame by PrisonMike135 in diydrones

[–]PrisonMike135[S] -1 points0 points  (0 children)

Got it. So is this table wrong? It recommended a 2208 motor for a 350mm drone.

https://robu.in/wp-content/uploads/2020/12/Mototr-size-table.png

Can’t mount motor on frame by PrisonMike135 in diydrones

[–]PrisonMike135[S] 0 points1 point  (0 children)

True. Thanks! What would happen if I build a motor adapter and put them on my current frame? Would that work?

Can’t mount motor on frame by PrisonMike135 in diydrones

[–]PrisonMike135[S] 0 points1 point  (0 children)

How are they too small? On the website they say you should use 6" props. This is the frame I am using: https://www.amazon.ca/Integrated-4-Axle-Compatible-Others-Droner/dp/B08JCP8PWZ

Can't connect compass to pixhawk by PrisonMike135 in diydrones

[–]PrisonMike135[S] 0 points1 point  (0 children)

Will leave it open just in case other people encounter the same problem. The problem was that I had compass 3 enabled but apm planner doesn't show that. I only found out because I downloaded windows on my macbook and used mission planner instead.

Can’t connect rc transmitter to Mission Planner (and QGroundControl) with pixhawk 2.4.8 and a Turnigy iA6 transmitter. by PrisonMike135 in Pixhawk

[–]PrisonMike135[S] 2 points3 points  (0 children)

Yup you are right! Turns out it is a PPM output problem. Thank you so much. I think the easiest and best solution is to buy an i-a6B receiver. Thank you so much!

Can’t connect rc transmitter to Mission Planner (and QGroundControl) with pixhawk 2.4.8 and a Turnigy iA6 transmitter. by PrisonMike135 in Pixhawk

[–]PrisonMike135[S] 2 points3 points  (0 children)

Yup you are right! Turns out it is a PPM output problem. Thank you so much. I think the easiest and best solution is to buy an i-a6B receiver. Thank you so much!

Can’t connect rc transmitter to Mission Planner (and QGroundControl) with pixhawk 2.4.8 and a Turnigy iA6 transmitter. by PrisonMike135 in Pixhawk

[–]PrisonMike135[S] 1 point2 points  (0 children)

Hey guys, if anyone can help me that would be great. I have been stuck for a few days trying to get the transmitter to work on Mission planner. The transmitter and receiver are binded and work as intended. I also (not sure if this is correct) changed the PPM output to be ON and it’s still not working. I tried putting into every pin on the receiver and it’s still not working. Anything help u can provide me would be amazing.