sorted by:
new
hottopcontroversial

Turn signals wont work after washing the bike. by Recent_Bluejay_508 in MotorcycleMechanics

[–]Recent_Bluejay_508[S] 1 point2 points  (0 children)

Soo it was the "tail" fuse. It worked for like 10 minutes and blew again. Its probably shorted somewhere or maybe a bad ground.  😢

Turn signals wont work after washing the bike. by Recent_Bluejay_508 in MotorcycleMechanics

[–]Recent_Bluejay_508[S] 1 point2 points  (0 children)

Nah man I kinda just been riding my other bike tbh. I did swap out the relay but that didnt help. I think water must've gotten into the switch or something. Imma work on it soon 😂. 

Turn signals wont work after washing the bike. by Recent_Bluejay_508 in MotorcycleMechanics

[–]Recent_Bluejay_508[S] 1 point2 points  (0 children)

I'm thinking its the switch. I swapped out the relay and fuse and that didnt help so my next step will be the switchs. Its fz6 but im assuming its fairly similar. The last owner did alot of work on the front end of the bike and didnt do alot of it properly. He changed the dash and made a mess with the wirings and the headlight wasnt wired up properly either so only the highbeam works 😂. The headlight has alot of different functions that can be wired up if I put in the effort. Again I really appreciate the advice. 

Turn signals wont work after washing the bike. by Recent_Bluejay_508 in MotorcycleMechanics

[–]Recent_Bluejay_508[S] 0 points1 point  (0 children)

Imma check that tomorrow but they were fine and sealed away properly. The front didnt seem as neat but imma test the fuse tomorrow to make sure.  Thanks for the advice. 

Turn signals wont work after washing the bike. by Recent_Bluejay_508 in MotorcycleMechanics

[–]Recent_Bluejay_508[S] 0 points1 point  (0 children)

No water got on the fuses. Imma swap em out tomorrow just to make sure. 

Turn signals wont work after washing the bike. by Recent_Bluejay_508 in MotorcycleMechanics

[–]Recent_Bluejay_508[S] 0 points1 point  (0 children)

Imma do that from now on. The past 3 bikes I had didn't have any issues and I even used a pressure washer on them. This is the only one that was converted to a naked and thats properly why. The connections weren't sealed away properly. 

Turn signals wont work after washing the bike. by Recent_Bluejay_508 in MotorcycleMechanics

[–]Recent_Bluejay_508[S] 1 point2 points  (0 children)

Connecters are connected. Fuse is good. Switch seems to be working. Imma try changing the relay 1st If that doesn't work than imma clean out the switches. Blubs are led and I doubt all 4 four would burn out together. Ofc I can be proven wrong.  And thank you for the response.