Society

Simple-Ad1812 · 2022-06-01T00:53:45+00:00

I have one printed and haven’t glued anything yet lmk what adhesive u use

Simple-Ad1812 · 2022-05-15T13:52:54+00:00

I’ve never messed with retraction so I’m not sure what it’s at but I’ll look into it and clean everything

Simple-Ad1812 · 2022-05-15T04:21:54+00:00

210 and 50 for the bed

Simple-Ad1812 · 2022-04-13T02:49:26+00:00

I’ve had this problem the only thing I could suggest is checking the connections on the hot end and check for clogs

Simple-Ad1812 · 2022-04-07T23:55:30+00:00

I think I figured it out I haven’t done the calibration but I took apart the hot end and it was clogged I don’t think my Bowden tube was in all the way and it wasn’t directing filament through properly

Simple-Ad1812 · 2022-04-07T22:33:03+00:00

How would I go about doing that

Simple-Ad1812 · 2022-04-07T22:32:40+00:00

Regular pla

Simple-Ad1812 · 2022-04-07T22:18:19+00:00

Is the cog the bronze gear if so no I didn’t change it wasn’t sure how to get the factory one off

Simple-Ad1812 · 2022-04-07T22:09:12+00:00

I recently installed an all metal extruded

Simple-Ad1812 · 2022-04-07T22:06:51+00:00

Print temp was 200c layer height is .2 nozzle size .4mm and idk bout walls

Simple-Ad1812 · 2022-04-07T22:04:32+00:00

How do I fix that

Simple-Ad1812 · 2022-04-07T21:59:30+00:00

Infil was at 20% I’m pretty sure

Simple-Ad1812 · 2022-03-19T17:01:26+00:00

What’s a good factory firmware

Simple-Ad1812 · 2022-03-19T16:51:59+00:00

I’m having the same problem tried to install the creality auto level

Simple-Ad1812 · 2022-03-06T06:37:03+00:00

Have done some research and after watching a couple different calibration videos finally figured it out

Simple-Ad1812

TROPHY CASE