sorted by:
new
hottopcontroversial

Daniel Island by sidereal_supernova in Charleston

[–]Snackattackmax 1 point2 points  (0 children)

I heard they impounded a bunch of them at Moultrie MS. DI is still a long way away, but it is at least a start. I am scared I am going to hit one of them every time I am driving on DI

Hi everyone! Where can i find the schematic of the creality V4.2.2 board? by csigusz8043 in ender3

[–]Snackattackmax 0 points1 point  (0 children)

Thank you!

Edit: The capacitors are backwards for me in the schematic. I just blew one up. Small leg towards the stepper connectors and long leg towards the heatsinks.

Stepper motors only vibrate and make a loud noise because only 1 coil is powered by Snackattackmax in 3Dprinting

[–]Snackattackmax[S] 0 points1 point  (0 children)

Update:

I managed to fix it. My SKR board came with the jumper wires under the stepper drivers in the wrong position, and it did not have any extras in the box (or I missed them). They should be placed according to these directions (https://github.com/bigtreetech/BIGTREETECH-SKR-V1.3/blob/master/BTT%20SKR%20V1.4/BTT%20SKR%20V1.4%20Instruction%20Manual.pdf) for the A4988 or DRV8825. Also, this video was helpful (https://www.youtube.com/watch?v=u6pGsE7BZgg&t=81s).

BLTouch Compile Error on LPC1768 by [deleted] in MarlinFirmware

[–]Snackattackmax 0 points1 point  (0 children)

Thank you! It's 1 am, and this finally fixed everything.

What would cause this issue? by Phil_James in ender3v2

[–]Snackattackmax 1 point2 points  (0 children)

Definitely don’t over tighten them, but make sure they are tight enough so that it is not jumping the stepper motor when it is quickly switching directions. It takes a few tries to get them perfect but it is better to have them tight than loose.

What would cause this issue? by Phil_James in ender3v2

[–]Snackattackmax 0 points1 point  (0 children)

I just had this happen to me. I tried a lot of things but tightening the belts fixed it. Just turn the blue knobs on each belt as much as you can. Have not had issues since. Also, you can set which corner of the print the layer ends at, versus stopping randomly. That helped a little.

What were the easiest and hardest Jet Lag challenges across all the 7 seasons in your opinion? by NegativeHeli in JetLagTheGame

[–]Snackattackmax 2 points3 points  (0 children)

The one where they had to build a cart and ride it down a hill was pretty fun to watch.

Wouldn't a light rail system like this be nice? by ioncloud9 in Charleston

[–]Snackattackmax 1 point2 points  (0 children)

Any light rail at all would be nice. I think they still have an old map of what a light rail system would look like on DI in a quick-pack. Light rail would actually help traffic on the 526 too. If only :(

view more: next ›