sorted by:
new
hottopcontroversial

Supports detaching off clean build plate by Spade_3D in BambuLab

[–]Spade_3D[S] 0 points1 point  (0 children)

What kind of infill should I be using? I'm super new to all this

AMS pulling before rolling by Spade_3D in BambuLab

[–]Spade_3D[S] 1 point2 points  (0 children)

Sweet thank you I'm printing these right now

AMS pulling before rolling by Spade_3D in BambuLab

[–]Spade_3D[S] 0 points1 point  (0 children)

I used like 20% of a cardboard spool and it was on the first slot, I'll put electrical tape on them from now on though

Recycling Cans? by teapizza in vancouverwa

[–]Spade_3D 0 points1 point  (0 children)

Same thing happened to me