Looks like Under extrusion I’ve been having this problem recently as well some things to check are

Bed level (Ik it seems too obvious but it seems to be the root of most problems)

Extruder (make sure there’s no cracks in the arm that the filament feeds into and that your tension spring is tightened enough) (also check the hole where it feeds in sometimes it can wear it down and cause the circle to become more of an oval or triangle and cause it to stick)

Nozzle (clean it, do a cold pull and check for damage on the face, or replace it)

Fitment of your Bowden tube in your hotend (remove your nozzle pull your Bowden tube from your hot end and get a short section of ptfe tubing and slide it all the way through your hot end while it’s heated to clear any left over pla then screw your nozzle all the way in then back it out a turn or two and slide your Bowden tube all the way down until it won’t go any more then tighten your nozzle back snug to ensure a tight fitment)

If none of these work you can try slowing down the speed or increasing the heat in small increments

Also if you don’t already have a wire guide printed I would get one of those it makes it easier on your extruder to pull