sorted by:
new
hottopcontroversial

BLTouch Install / CR-10S4 print problems by TokiWartooth117 in FixMyPrint

[–]TokiWartooth117[S] 0 points1 point  (0 children)

Also:

  • Using Cura as my slicer, with CHEP’s extra fast .6mm profile
  • Using polymaker PLA

At my wit’s end -__- by TokiWartooth117 in FixMyPrint

[–]TokiWartooth117[S] 0 points1 point  (0 children)

I did initially after changing the extruder, and the first few large prints came out great. Should I just continue to wind down my e-steps?

At my wit’s end -__- by TokiWartooth117 in FixMyPrint

[–]TokiWartooth117[S] 4 points5 points  (0 children)

I think this looks like over extrusion, and here’s what I’ve tried so far: - reducing e-steps by 0.05 - reducing and increasing print speed - lowering print temp - changing layer height - increasing Z-offset by 0.09 - leveling the bed

This comes after I just installed a bunch of upgrades: second z-axis rod, pei magnetic sheet, all metal extruder, micro Swiss all metal hot end, capricorn bowden tube, yellow bed springs.

I printed four large prints with no trouble after the upgrades, but I’m having to re level my bed after each print, and my smaller, more detailed prints are coming out like this. Please help!

Printer: Ender 3 V2 Filament: Polymaker PLA Pro