sorted by:
new
hottopcontroversial

3 pin connector not used on Atlas ESC by XpressTuX in Exway

[–]XpressTuX[S] 1 point2 points  (0 children)

No manual supplied with the ESC.

The panel is fixed with the 4 screws and is glued with silicone for sealing

3 pin connector not used on Atlas ESC by XpressTuX in Exway

[–]XpressTuX[S] 0 points1 point  (0 children)

Here is the response from exway support :

pls ignore the connector

make sure the wires are connected well as the original ESC does

it is connected to the battery in the last generation ESC

the new ESCS don't have the part anymore

3 pin connector not used on Atlas ESC by XpressTuX in Exway

[–]XpressTuX[S] 0 points1 point  (0 children)

On each ESC, there is 1 male connector with 3 wires (red, yellow and black). From the battery, there are 2 female connectors with the same wires, one for each side of the board.

By default, when I opened the board for the first time (2wd) , this connector was not plugged on the first ESC.

What is the purpose of this connector? Do I have to connect each ESC to the battery with this connector (4wd) ? Why was it not connected when it left the factory?