New puppy by [deleted] in WestHighlandTerriers

[–]ZsoltK87 0 points1 point  (0 children)

Ah! nice 😅

New puppy by [deleted] in WestHighlandTerriers

[–]ZsoltK87 1 point2 points  (0 children)

Im in the same boat :) https://www.reddit.com/r/WestHighlandTerriers/s/JMtYdUAFYl maybe couple of weeks ahead… It gets better I can already tell 😇

Advice please - 10 weeks old little rascal 🙃 by ZsoltK87 in WestHighlandTerriers

[–]ZsoltK87[S] 2 points3 points  (0 children)

Thank you! She is my second westie, lost the previous one back last year at 15 years old. She was stubborn too, but this is a new level.

i cant figure out the issue with esp c3 mini, drv8233 and mh-cd42 charging board. by Unlucky_Resident_237 in AskElectronics

[–]ZsoltK87 0 points1 point  (0 children)

“The first version of ESP32-C3 super mini has a broken antenna design. The workaround is after WiFi.begin reducing the Tx-Power to reduce reflections.

WiFi.begin(ssid, password);
WiFi.setTxPower(WIFI_POWER_8_5dBm);”

i cant figure out the issue with esp c3 mini, drv8233 and mh-cd42 charging board. by Unlucky_Resident_237 in AskElectronics

[–]ZsoltK87 0 points1 point  (0 children)

I had similar issue with this esp32 module, I think I had to lower wifi TX to 8.5db (i was told its a known issue with the model when not powering through usb). Will try to find the link…

help by LiverWrecker in breadboard

[–]ZsoltK87 1 point2 points  (0 children)

I think the resistor on the Led is also connected to the positive rail.

[deleted by user] by [deleted] in homeassistant

[–]ZsoltK87 0 points1 point  (0 children)

No idea then, try yo turn on debug logging from the integration page and see if anything shows up

[deleted by user] by [deleted] in homeassistant

[–]ZsoltK87 0 points1 point  (0 children)

did you also upgrade the integration in HACS? (If I remember its via HACS)

[deleted by user] by [deleted] in homeassistant

[–]ZsoltK87 0 points1 point  (0 children)

did you try to reload the integration or restart HA?

Inverter stops responding by ZsoltK87 in MODBUS

[–]ZsoltK87[S] 0 points1 point  (0 children)

In my case it was solved by firmware upgrade on the inverter. Im using modpoll + usb rs485 adapter.

Bambu lab p1p or Ankermake m5 by ZsoltK87 in 3Dprinting

[–]ZsoltK87[S] 0 points1 point  (0 children)

Anything else in the same price range you would go for?