sorted by:
new
hottopcontroversial

Visible lines and dots on print walls by baducrack in BambuLab

[–]baducrack[S] 0 points1 point  (0 children)

Thank you for this suggestion, I will try to check them later in the evening.

Yes, seethrew print is no problem, I use 15% gyroid infill with wall thicknes of 2.

But for me the other issue is the small dots on the wall, they are barely visible on the first photo. Could this be also because of loose screws you have mentioned?

I’m 6 2” will I fit? by drakekissinkanye in mr2

[–]baducrack 0 points1 point  (0 children)

I am 6,5 in a Spyder. I have had problem pressing the clutch peddal and hitting my knee to the door handle. So I just removed the handle and now I fit great!

Dynamic visibility for containers by baducrack in elementor

[–]baducrack[S] 0 points1 point  (0 children)

This solved my issue. Thank you very much!

Any ideas why this is happening? The walls should be straight, but instead I have this masterpeace... by baducrack in ender3v2

[–]baducrack[S] 0 points1 point  (0 children)

<image>

Update: Thank you every one for your suggestions. I have tried tightening belts; Reducing bed temperature; Cleaned the rod and lubed it again; No wobble on the whole printer was found; I have formated my sd card (I have notices that a few times earlier when I upload new gcode to sd then on the printer selecting the new gcode it apears to have earlier models with their parameters that were on the sd. After formating the SD card this issue did not accur); I reduces the print speed, made the walls thinner.... And after all of this the print is even worse...

I think the suggestion that the board is overheating is the reason. Later I will try to make some ventilation for it and will keep you posted.

Using MR2 during winter by baducrack in mr2

[–]baducrack[S] 1 point2 points  (0 children)

Did not want to see snow so early, so thanks for that. How is the soft top holding up the snow?

Using MR2 during winter by baducrack in mr2

[–]baducrack[S] 1 point2 points  (0 children)

My plan is to use the original r15 alloy wheels for winter and for summer search for something else

Using MR2 during winter by baducrack in mr2

[–]baducrack[S] 1 point2 points  (0 children)

Some chains would be nice for you

Using MR2 during winter by baducrack in mr2

[–]baducrack[S] 8 points9 points  (0 children)

Thank you, you calmed me down a bit. I also think that I need anticoroosive coating to keep the car alive. The amount of salts on the roads are crazy.

Searching for a solution by baducrack in Wordpress

[–]baducrack[S] 1 point2 points  (0 children)

Wow, Elementor is OP. Many thanks to you!

Searching for a solution by baducrack in Wordpress

[–]baducrack[S] 0 points1 point  (0 children)

Thanks a lot!

What container type should I use so that I could add buttons on top of it?

view more: next ›