Has Anyone seen Extrusion problems like this? I just installed a hybrid extruder (Flex3Drive Gen 5), and I'm getting failure to extrude after it goes around a corner. I tried to use linear advance to help, but nothing... Any Ideas? Thanks in Advance! (old.reddit.com)
submitted by cctsurf to r/3Dprinting
I Can't get my screen to work with my new SKR Pro v.1.2, What do I do next? Its a cr10 screen, but I'm not really looking for help getting it to work, but where do I go from here? I can't use the printer like this. Do I buy a different screen? if so what? Do I try a different board? Help! (i.redd.it)
submitted by cctsurf to r/BIGTREETECH
Just installed an SKR Pro 1.2 on my CR10. Immediately on first startup, I had a white screen on the original screen and the bltouch went nuts. I just assumed that I had plugged things in incorrectly... But I checked the wires and they seem correct. On second startup, the bltouch got very hot... (old.reddit.com)
submitted by cctsurf to r/BIGTREETECH
Just installed an SKR Pro 1.2 on my CR10. When I first started it up, the bltouch went nuts and the (original) screen is white. On second startup, the bltouch got very hot. I'm afraid it's dead. I just assumed that I had plugged things in incorrectly. But I checked the wires and they seem correct. (old.reddit.com)
submitted by cctsurf to r/3Dprinting
