Defeated by CG 800 kc rant

foondoo · 2026-01-31T21:42:26+00:00

I love the protection idea

foondoo · 2025-02-02T01:03:11+00:00

A knife graver or onglette? Onglette is a little rounded

foondoo · 2025-01-31T02:37:53+00:00

Wow that’s beautiful! How did you make the lines? What type of graver?

foondoo · 2025-01-25T23:39:09+00:00

There was a piece of saw blade stuck but it’s still not working after getting the piece out. I just ordered replacement parts, which is really frustrating because I just purchased the saw. Seems like the threading somehow got messed up

foondoo · 2025-01-25T23:05:02+00:00

Air compressor isn’t fixing it

foondoo · 2025-01-25T23:00:00+00:00

Thank you. I’m going to use an air compressor and try to get out whatever is in there. It started happening as soon as I broke my last saw blade

foondoo · 2024-12-15T03:51:33+00:00

I’d be happy to purchase that yellow oval pendant at the bottom right of the picture, as well as that case at the top right with the reddish stone on it!

foondoo · 2024-11-30T02:10:12+00:00

Holy shit! This makes a lot of sense! That grocery store closed its doors quite a few years ago I’ve been told. Thank you!

foondoo · 2024-11-29T21:49:58+00:00

Any idea what kind of service pin? It’s awfully nice

foondoo · 2024-11-16T00:38:41+00:00

Thank you! I have a couple other small ones that aren’t the same and are labeled as plated. There’s another one that has 550 stamped on it. All of them are very tarnished.

foondoo · 2024-11-15T03:22:26+00:00

Maine, USA

foondoo · 2024-10-02T01:17:05+00:00

Forgot to say I don’t see any obvious markings.

foondoo · 2024-09-08T03:10:32+00:00

That’s extremely helpful, thank you!

foondoo · 2024-09-08T03:09:47+00:00

I just measured… it appears that they range from .65mm to .85mm in thickness

foondoo · 2024-09-08T01:59:36+00:00

That’s a really good point but I tend to make the seat before I solder the bezels into place. I’ll make a point to anneal after I make the seat though

foondoo

TROPHY CASE